Appliance Handling Safety; Safety Codes And Standards; Electric Safety; Gas Safety - Gaggenau VG 232 CA Instrucciones De Instalación

,
IMPORTANT SAFETY INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
INSTALLER: LEAVE THESE INSTRUCTIONS WITH
THE APPLIANCE AFTER INSTALLATION IS
COMPLETE. IMPORTANT: SAVE FOR THE LOCAL
INSPECTOR'S USE.
,
WARNING: Do not repair, replace or remove any
part of the appliance unless specifically
recommended in the manuals. Improper
installation, service or maintenance can cause
injury or property damage. Refer to this manual
for guidance. All other servicing should be done
by a qualified technician.

Appliance Handling Safety

Hidden surfaces may have sharp edges. Use caution
when reaching behind or under appliance.

Safety Codes and Standards

This appliance complies with one or more of the
following Standards:
▯
UL 858, The Standard for the Safety of
Household Electric Ranges
▯
UL 923, The Standard for the Safety of
Microwave Cooking Appliances
▯
UL 507, The Standard for the Safety of Electric
Fans
▯
ANSI Z21.1, The American National Standard
for Household Cooking Gas Appliances
▯
CAN/CSA-C22.2 No. 113-M1984 Fans and
Ventilators
▯
CAN/CSA-C22.2 No. 61-M89 Household
Cooking Ranges
It is the responsibility of the owner and the installer to
determine if additional requirements and/or standards
apply to specific installations.
Installation must conform with local codes or, in the
absence of local codes, with the National Fuel Gas
Code, ANSI Z223.1.
The appliance must be electrically grounded in
accordance with local codes or, in the absence of
local codes, with the National Electrical Code ANSI/
NFPA 70, latest edition. (In Canada, installation must
be in accordance with the CAN 1-B149.1 and .2
Installation Codes for Gas Burning Appliances and/
or local codes.)

Electric Safety

For appliances equipped with a cord and plug, do not
cut or remove the ground prong. It must be plugged
into a matching grounding type receptacle to avoid
electrical shock. If there is any doubt as to whether
the wall receptacle is properly grounded, the
customer should have it checked by a qualified
electrician.
If required by the National Electrical Code (or
Canadian Electrical Code), this appliance must be
installed on a separate branch circuit.
Installer – show the owner the location of the circuit
breaker or fuse. Mark it for easy reference.
Before installing, turn power OFF at the service panel.
Lock service panel to prevent power from being
turned ON accidentally.
Be sure your appliance is properly installed and
grounded by a qualified technician. Installation,
electrical connections and grounding must comply
with all applicable codes.

Gas Safety

Install a gas shutoff valve near the appliance. It must
be easily accessible in an emergency.
Leak testing must be conducted by the installer
according to the instructions in this manual.
The appliance and its individual shutoff valve must be
disconnected from the gas supply piping system
during any pressure testing at pressures in excess of
½ psi (3.5 kPa).
The appliance must be isolated from the gas supply
piping system by closing its individual manual shutoff
valve during any pressure testing of the gas supply
piping system at test pressures equal to or less than
½ psi (3.5 kPa).
The minimum supply pressure must be 1" water
column above the manifold pressure printed on the
data plate.
The maximum supply pressure must not exceed 14.0
inches water column (34.9 Millibars).
3