DOOR PANEL INSTALLATION
P
lace the nameplate label of the push buttons.
Twist the call wires as shown. The call wires should be
connected to the sound module El520 or to the
corresponding push buttons encoder.
Open the label holder.
For a quality finish, pass the wires through the hole
arranged on the nearest module holder. It is advisable to
use wires with sections between 0,1 and 0,25mm .
VERY IMPORTANT: Link the push buttons common terminal
of the several push buttons modules. The push buttons of
the same module are linked from factory.
This wire must be connected to the CP terminal of the
sound module EL520 and to the corresponding CP
terminal of the encoder circuit (if there is).
55
Place the label
and close.
P
ush button wiring.
2