Electronic Circuit Assembly; Door Panel Fixation - golmar 2PLUS Serie Manual De Instalación

54
F
ixing the door panel into the embedding box.
To hold the door panel on the embedding box,
insert the hinge springs into the embedding
box bolts as shown.
To place the module EL516SE (or EL 512),
center the hole on the upper side of the module cover with the corresponding
hole in the embedding box.
Lean the circuit on the lower flanges and screw it to the embedding box. In such case there are
more modules of the same type, repeat this procedure further below, or on the next box.
DOOR PANEL INSTALLATION
Insert the sound module in the grille module. For a
Choose a direction to open the door panel; this selection should
facilitate the door panel wiring.
The opening direction is determined by the location of both hinge
springs, that have to be introduced through the clips which are found
at the end of the headers as it is shown in the picture. For example, if
the springs are placed on the two clips of the lower header, the door
pannel will open downwards; if they are placed on the right clips of
both headers, the door panel will
open to the left.
S
ound module assembly.
proper assembly, align the light push button
and the microphone of the sound module with
its own holes in the grille module.