Connecting The Power Cord - Pioneer AVH-P5000DVD Manual Del Instalacion

Connecting the Units

Connecting the power cord

Note:
Depending on the kind of vehicle, the
function of 3* and 5* may be different.
In this case, be sure to connect 2* to 5*
and 4* to 3*.
3*
5*
Cap (1*)
Do not remove cap if this
terminal is not in use.
Yellow (3*)
Back-up
(or accessory)
Red (5*)
Accessory
(or back-up)
Orange/white
Connect to lighting switch terminal.
Black (chassis ground)
Connect to a clean, paint-free metal location.
ISO connector
Note:
In some vehicles, the ISO connector may be
divided into two. In this case, be sure to
connect to both connectors.
When you connect the separately sold multi-
channel processor (e.g., DEQ-P6600) to this
unit, do not connect anything to the speaker
leads and system remote control
(blue/white).
5
Wired remote input
Hard-wired remote control adaptor
can be connected (sold separately).
1*
2*
4*
USB cable (supplied)
Connect to separately sold
USB device.
Yellow (2*)
Connect to the constant 12 V
supply terminal.
Red (4*)
Connect to terminal controlled by
ignition switch (12 V DC).
20 cm
USB input
1.5 m
Connect leads of the same
color to each other.
Fuse (10 A)
Speaker leads
Front left +
White:
White/black: Front left ≠
Front right +
Gray:
Gray/black: Front right ≠
Rear left + or subwoofer +
Green:
Green/black: Rear left ≠ or subwoofer ≠
Rear right + or subwoofer +
Violet:
Violet/black: Rear right ≠ or subwoofer ≠
Gray
This product
Fuse resistor
Fuse resistor