Fuel; Connect A Lpg/Propane Tank - Westinghouse iGen4500DF Manual De Usuario

Ocultar thumbs Ver también para iGen4500DF:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

ASSEMBLY

FUEL

Fire and explosion hazard. Never use a gasoline
container, gasoline tank, propane connector hose,
propane tanks, or any other fuel item that is broken, cut,
torn or damaged.
Fire and explosion hazard. Do not overfill fuel tank. Fill
only to the red fill ring located in the in-tank fuel screen
filter. Overfilling may cause fuel to spill onto engine
causing a fire or explosion hazard.
Fire and explosion hazard. Never refuel the generator
while the engine is running. Always turn the engine off
and allow the generator to cool for two minutes before
refueling.
Do not use E15 or E85 fuel in this
product.
damage caused by stale fuel or
E85 E15
the use of unapproved fuels (such
as E15 or E85 ethanol blends) is
not covered by warranty. Only use
unleaded gasoline containing up to
10% ethanol.
FUEL REQUIREMENTS
• CLEAN, FRESH, unleaded gasoline, 87–93 octane.
• Up to 10% ethanol (gasohol) is acceptable (where
available; non-ethanol fuel is recommended).
• DO NOT use E85 or E15.
• DO NOT use a gas oil mix.
• DO NOT modify the engine to run on alternate fuels.
• DO NOT fuel indoors.
• DO NOT create a spark or flame while fueling.
USING FUEL STABILIZER
Adding a fuel stabilizer (not included) extends the usable
life of fuel and helps prevent deposits from forming that
can clog the fuel system. Follow the manufacturer's
instructions for use.
Always mix the correct amount of fuel stabilizer to gasoline
in an approved gasoline container before fueling the
generator. Run the generator for five minutes to allow the
stabilizer to treat the entire fuel system.
12 | Westinghouse Outdoor Power Equipment, LLC
WARNING
DANGER
DANGER
NOTICE
Engine
or
FILLING THE FUEL TANK
1. Turn the generator OFF and allow to cool for a minimum
of two minutes before fueling.
2. Place the generator on level ground in a well ventilated
area.
3. Clean area around fuel cap and remove the cap slowly.
Only fill the tank from an approved gasoline container.
Make sure the gasoline container is internally clean and
in good condition to prevent fuel system contamination.
4. Slowly add the recommended fuel. Do not overfill. Fill
only to the red maximum fill ring on the fuel screen filter
visible in the filler neck.
equipment
5. Install the fuel cap and tighten until a click is heard.
Fuel can damage paint and plastic. Use caution when
filling the fuel tank. Damage caused by spilled fuel is not
covered under warranty.
Clean the fuel screen filter of debris before and after
each fueling. Remove the fuel screen filter by slightly
compressing it while removing it from the fuel tank.

CONNECT A LPG/PROPANE TANK

• The LPG/propane tank can be of any capacity but the
tank must conform to the standard as listed in Fuel
Safety section.
• Propane tanks that use liquid withdrawal system can
not be used on these models.
• Verify the re-qualification date on the tank has not
expired.
• Do not use included LPG/propane hose for any other
appliances.
NOTICE
Fuel Cap
Screen
Filter
NOTICE
NOTICE
NOTICE
Maximum
Fuel Level
Tabla de contenido

Solución de problemas

loading

Tabla de contenido