Light Kit Assembly; Testing Your Fan - Craftmade Builder Deluxe Guia De Instalacion

10. Light Kit Assembly.

Secure 3 glass shades with
thumbscrews provided in one of
the hardware packs.
Do NOT overtighten thumbscrews as
glass may crack or break.
Install 3 candelabra base 60 watt max.
incandescent bulbs (included).
IMPORTANT: When you need to
replace bulbs, please allow bulb(s) and
glass shade(s) to cool down before
touching them.

11. Testing Your Fan.

It is recommended that you test fan before
finalizing installation. Restore power from
circuit box and light switch (if applicable). Test
fan speeds with the pull chain located on the
switch housing. Start at the OFF position (no
blade movement). First pull will set the fan to
HI. Second pull will set the fan to MEDIUM.
Third pull will set the fan to LOW. Fourth pull
will again set the fan to OFF setting. Test lights
with the pull chain located in the middle. If fan
and/or lights do/does not function, please refer
to "Troubleshooting" section to solve any issues
before contacting Customer Service.
Turn fan completely off before moving the
reverse switch. Set reverse switch to recirculate
air depending on the season:
- DOWN position in summer (diagram 1)
- UP position in winter (diagram 2)
A ceiling fan will allow you to raise your
thermostat setting in summer and lower your
thermostat setting in winter without feeling a
difference in your comfort.
Important: Reverse switch must be set either
completely UP or completely DOWN for fan to
function. If the reverse switch is set in the
middle position (diagram 3), fan will not
operate.
Attach pull chain extension(s) provided or
custom pull chain extension(s) (sold separately)
to the end(s) of the pull chain(s).
switch housing
light kit fitter
bulb
diagram 1
page 9
reverse switch
(for
light)
glass shade
diagram 2 diagram 3
(for fan)
pull chain
extensions