Getting Started - Medisana MTD Instrucciones De Manejo

3 Getting Started

3.1
Inserting /
removing batteries
3.2
Using a Mains
Adaptor
2 Useful Information / 3 Getting Started
• Measure your blood pressure before meals.
• Before taking readings, allow yourself at least five minutes rest.
• If the systolic and diastolic readings seem unusual (too high or too low) on
several occasions, despite correct use of the unit, please inform your doctor.
This also applies to the rare occasions when an irregular or very weak pulse
prevents you from taking readings.
Insertion: Open the battery compartment on the underside of the unit by
exerting gentle pressure, and insert the four batteries included with the unit
(alkaline batteries, AA type, LR 6). Remember to insert the batteries as indi-
cated in the diagram in the battery compartment. Replace the lid, pressing it
until it snaps into place.
Removal: When the battery symbol
place the batteries with new ones.
After batteries be inserted, the display will display the defaulted date & time.
Set the date and time as described in 3.3 Set Date and Time. Please note that
the date and time will have to be reset each time new batteries are inserted.
The previous measuring results are saved.
WARNING
BATTERY SAFETY INFORMATION
• Keep away from children!
• Do not recharge!
• Do not short-circuit!
• Do not throw into fire!
There is a danger of explosion!
• Do not dispose of old batteries with your household waste,
but dispose of them at a battery collection station at a
recycling site or in a shop!
Alternatively, the unit may also be operated with a special power adapter
(MEDISANA item no. 51125), which is plugged into the connector
at the back of the unit. In this case the batteries remain in the unit. The batte-
ries are disconnected mechanically when the connector is inserted into the
back of the blood pressure monitor. It is necessary, therefore, to plug the mains
adaptor into the mains socket first of all and then to connect it to the blood
pressure monitor. If the blood pressure monitor is no longer being used, first
remove the connector from the blood pressure monitor and then pull the mains
adaptor out of the mains socket. Doing this means that the date and time will
not have to be reset each time.
appears in the display, please re-
GB
provided
17