Optional Adaptors - Sony GXD-L52H1 Manual De Instrucciones

Optional Adaptors

The terminal of the OPTION slot 9 (page 10) on the
side of the equipment is a slot-in type. It can be
switched to the following optional adapter (not
supplied).
For details on installation, consult your Sony dealers.
For details on the optional adaptors for system
expansion, BKM-FW series, see each instruction
manual.
COMPONENT/RGB INPUT Adaptor BKM-
FW11
1 Y/G, P /C /B, P /C
B B R R
the analog RGB signal or component signal output
of a piece of video equipment or PC.
2 HD, VD IN (BNC): Connects to the
synchronization signal output of a PC.
Note
When inputting a component signal, be sure not to input sync
signals to the HD and VD connectors. If you do so, the
picture may not be displayed properly.
3 AUDIO (Stereo mini jack): Inputs an audio
signal. Connects to the audio output of a piece of
video equipment or PC.
HDMI INPUT Adaptor BKM-FW15
1 HDMI 1/HDMI 2 IN: HDMI (High-Definition
Multimedia Interface) provides an interface
between the display and any HDMI-equipped
audio/video equipment, as well as PC. You can
enjoy enhanced or high-definition video, and two-
channel digital audio. You can also connect a
piece of DVI-equipped equipment to your display
by using an HDMI-to-DVI cable (not supplied).
The appropriate mode for a piece of audio/video
equipment or PC is automatically selected in
accordance with the connected equipment.
/R IN (BNC): Connects to
Note
Be sure to use only an HDMI cable (not supplied) that bears
the HDMI logo. We recommend that you use a Sony HDMI
cable (high speed type).
HD-SDI/SDI INPUT Adaptor BKM-FW16
Connects to the HD-SDI signal output of a piece of
video equipment.
For details, see the instruction manual of the BKM- FW16.
MONITOR CONTROL Adaptor BKM-FW21
1 CONTROL S IN/OUT (Mini jack): You can
control pieces of multiple equipment with a single
remote control when the display is connected to
the CONTROL S connector of the video
equipment or another display. Connect the
CONTROL S OUT connector on this adaptor to
the CONTROL S IN connector of the other
equipment, and connect the CONTROL S IN
connector on this adaptor to the CONTROL S
OUT connector of the other equipment.
2 REMOTE (D-sub 9-pin): This connector allows
remote control of the display using the RS-232C
protocol. For details, contact your authorized
Sony dealers.
Notes
• The REMOTE connector and the REMOTE (LAN)
connector 3 (page 9) on the side of the equipment
cannot be used at the same time.
• When using the REMOTE connector, select "Option" in
"Network Port". (page 31)
STREAMING RECEIVER Adaptor BKM-FW50
For details, see the instruction manual of the BKM-
FW50.
Note
You cannot use the REMOTE connector of this display if the
adaptor is connected to this display.
GB
17
GB