Sony GXD-L52H1 Manual De Instrucciones página 78

30
GB
Note
When this item is operated, the available modes will differ depending on whether you
select by the remote control or the display. When setting this item with
control, you can select only "Display+Remote" or "Remote Only". When setting this
(ENTER)
item with
"Display Only".
"Auto Screen Adjust"
"On": The settings such as picture size and position are saved for each input
signal, and the last settings are automatically applied each time the input signals
are switched.
"Off": The "Auto Screen Adjust" is disabled even when input signals are
switched and the default settings are applied.
Note
The "Auto Screen Adjust" function only works during RGB input.
"Auto Shut Off":
"On": The display automatically enters the standby mode when a signal is not
input to the Video or S Video input connectors for more than about 5 minutes.
The display automatically enters the power saving mode when a signal is not
input to the DVI, HDMI or HD15 (RGB/Component) input connectors for more
than about 30 seconds.
"Off": The display is not turned off automatically even when no signal is input
to any connector.
Tips
• While in the standby mode, press the 1 (POWER) switch on the display or the POWER
ON switch on the remote control to turn the display on. In the power saving mode, the
display is turned on automatically when a signal is input.
• This function is not available when "On-Screen Logo" is set to "On", the screensaver
function is activated, or PAP is selected.
"Overscan": Selects whether to display images with overscan or justscan.
"Auto": Switches automatically signal image which are supposed to be DTV to
image with overscan.
"On": Displays image with overscan.
"Off": Displays image with justscan.
Note
If "Overscan" is set to "Off," DTV signal image may be displayed like PC signal display.
Example: 480P t 720 × 480/60 "Sync Mode": Sets the mode according to the signal input at pin 13 of the HD15
(RGB/COMPONENT) IN connector.
"H/Comp": Select when a horizontal synchronous signal or a composite
synchronous signal is input.
"Video": Select when a video signal is input.
Notes
• "Sync Mode" is available only when analog RGB signal is input to HD15 connector.
• Depending on the level of the composite synchronous signal, the image may not be displayed
correctly. In this case, change the "Sync Mode" setting.
• There are some inputs for which only synchronizing signals can be selected. In this case,
input horizontal/vertical synchronization signals through the pin 13 or 14 of the connectors.
• Sync Mode settings cannot be carried out for the input through the optional adaptors.
• When "Video" is selected in "Sync Mode", you can only set the 575/50i and 480/60i signals.
• When you select the video signal for the synchronous mode setting, you cannot use the PAP
function.
on the display, you can select only "Display+Remote" or
on the remote