Basic Operation - KlipXtreme TwinBuds II Manual Del Usuario

Ocultar thumbs Ver también para TwinBuds II:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

LED indicators on earbuds
Status
Charging
The LED turns solid red
Charging complete
The LED turns off
Power on
The LEDs light up in blue in both
earphones, then the left earphone LED
blinks red and blue. The right earphone
LED blinks blue every 5 seconds
Power Off
The LED lights flash red, then turns off
Pairing mode
The LED in the right earphone will turn
active
solid blue and the LED in the left one will
blink blue and red alternatively. Refer to
section 4 for more information
When the device has paired, only the blue
Bluetooth
®
wireless pairing
LED will blink once every 5 seconds in both
earphones
Standby
The LED in the right earphone stays solid
blue and in the left earphone stays solid red
Low battery
Red LED blinks every second
Incoming call/
Blue LED lights up once every 5 seconds
Dialing
Phone is on
Blue LED lights up once every 5 seconds
active call

3. Basic operation

3.1. Charging the case and earphones
Note:
• The case and earphones have internal,
non-removable, rechargeable batteries. Do
not attempt to remove the battery as you
may damage the device.
Function
• Although the case and earphones can be
charged at the same time, it is recommended
to fully charge the case battery before
charging the earphones for the first time.
1. To charge the case, plug the supplied USB
cable into a power source and the
micro-USB end in the case's port. The case
starts charging automatically.
2. Charging the case battery to its full capacity
may take about 1.5 hours.
3. When the battery is fully charged, the LED
indicator lights will become solid white.
4. Proceed to unplug the case from the power
source and place the earphones on the
sockets of the charging case.
5. The case starts charging automatically, if not,
turn on the Multifunction button to start
charging the batteries of the earphones.
6. While the earphones are being charged, the
red indicator on each side lights up. When
fully charged, the LED will turn off. This
process will normally take about 1.5 hours.
7. The fully charged buds have power for up
to 7 hours of talking time or up to 120
hours of standby time. However, these
times may vary
Tabla de contenido
loading

Este manual también es adecuado para:

Khs-706

Tabla de contenido