KlipXtreme TwinBuds II Manual Del Usuario página 7

2. Double press the multifunction button of
one of the earphones. This will disconnect
the earphones from each other and put
them both into Mono mode.
3. You will notice that both earphones will
enter pairing mode (the LED on each of the
earbuds will blink blue), this will allow you to
bind each individual earphone to your
mobile device
4. Place the phone and earphones within one
meter of each other. Select the KHS-706
earphone from the list of newly discovered
devices in your phone.
Note: The KHS-706 will appear twice in the
devices list. You will have to pair
Bluetooth
®
individually to each earbud.
5. Accept by pressing Yes or OK on the
device. If prompted, enter the passkey 0000
(4 zeros). Your device will confirm when
pairing is complete.
6. The "Your device is connected" prompt will
be heard when the devices have established
the wireless connection, and the LED will
change to pulsing in blue.To pair them back
together to stereo mode, unpair/forget the
earbuds from your mobile device first and
follow the steps 1-11 from the section 4.1.
Simply double press one of the units - this
allows one to pair with the other making
them a single unit.
4.3. Call management using your
wireless earphones
• When there is an incoming call, your phone
will ring, the blue LED will blink once every 5
seconds, accompanied by a tone through your
earphones.
• Briefly press the Multifunction button on any
earphone to pick it up. You may also press
the answer button on your cellular phone to
receive the incoming communication in your
earphones.
Note: Audio will be out of both earphones.
• To end a call, simply press the Multifunction
button on any earphone once again.
• To ignore an incoming communication and
send the caller to voicemail, press and hold
the Multifunction button on any earphone
for about two seconds.
• "Last number redialed" will be heard when
you press the Multifunction button three
times on any earphone to dial the last
number called.