Tabla de contenido
Idiomas disponibles
Idiomas disponibles
LED indicator light turns on Blue.
Standby status
LED indicator light turns on solid Blue.
Connected status
Using headset in
Bluetooth
®
AUX-in mode, the LED indicator automatically turns off.
Aux/BT Mode
III. Basic operation
Charging your headphones
• Plug one end of the supplied micro-USB cable to your headphones micro-USB
port and the other end into the USB port of your computer or to a 5VDC
500mAh to a USB adapter to fully charge the battery.*
• The headphones' battery should be initially charged for at least 5 hours.
Thereafter, the battery will take about 3.5 hours to recharge.
• Make sure that the headphones are fully charged before using them for the first
time.
• When battery is low a voice prompt will be heard to indicate battery status.
*Do not use a USB fast charging or PD adapters with an output power greater than 5VDC or
you will damage your headphones and void the warranty.
mode- blue LED indicator light blinks slowly.
IV. Auxiliary wired connection
• With the headset ON you can insert the 3.5mm cable to switch to Aux in mode.
Plug one end of the supplied 3.5mm cable to your headphones and the other end
to the 3.5mm auxiliary port in your input source.
• The LED indicator on the headset will turn off and the headset will automatically
switch to aux in mode.
• Set the desired volume on the input source. The volume controls on the
headphone will not operate when they are connected to an external wired audio
source.
Note: Once you remove the cable you cannot return to Bluetooth
must turn the unit on again to enter Bluetooth
V. Advanced operation
Pairing the headset with your mobile phone
1. Turn on the device, the LED light will start in Bluetooth
blinking red and blue indicating that it is ready for pairing mode.
2. Next, set your Bluetooth
mobile device to "discover" the wireless headphones.
®
3. Place both devices not more than one meter away from each other.
mode, you
®
mode.
®
mode automatically,
®
Tabla de contenido
