Coolant - Benelli 302R Manual Del Propietário

Periodic maintenance and adjustment
8. Install the engine oil drain bolt and its
new gasket, and then tighten the bolt to
the specified torque.
Tightening torque:
EN
Engine oil drain bolt:
22 N·m (2.2 kgf·m, 16.2 lb·ft)
6
9. Refill with the specified amount of the
recommended engine oil, and then install
and tighten the oil filler cap.
Recommended engine oil:
API SJ, 15W-50, JASO MA CC MC G4
Oil quantity:
Oil change:
2.6 L (0.68 US gal, 0.57 Imp gal)
With oil filter removal:
2.8 L (0.73 US gal, 0.61 Imp gal)
TIP
Be sure to wipe off spilled oil on any parts
after the engine and exhaust system have
cooled down.
NOTICE
• In order to prevent clutch slip-
page (since the engine oil also
lubricates the clutch), do not mix
any chemical additives. Do not
use oils with a diesel specification
of "CD" or oils of a higher quality
than specified. In addition, do not
use oils labeled "ENERGY CONSER-
VING II" or higher.
• Make sure that no foreign mate-
rial enters the crankcase.
10. Start the engine, and then let it idle for
several minutes while checking it for oil
leakage. If oil is leaking, immediately turn
the engine off and check for the cause.
11. Turn the engine off, wait a few minutes
until the oil settles, and then check the oil
level and correct it if necessary.
6 - 12

Coolant

The coolant level should be checked befo-
re each ride. In addition, the coolant must
be changed at the intervals specified in
the periodic maintenance and lubrication
chart.
To check the coolant level
1. Place the vehicle on a lat surface and
keep it upright.
TIP
• The coolant level must be checked
on a cold engine since the level va-
ries with engine temperature.
• Make sure that the vehicle is positio-
ned straight up when checking the
coolant level. A slight tilt to the side
can result in a false reading.
2. Check the coolant level in the coolant
reservoir.