Tabla de contenido
Idiomas disponibles
Idiomas disponibles
LOADING NAILS
WARNING
When loading nails into Nailer,
1) do not pull trigger;
2) do not depress push lever; and
3) keep Nailer pointed downward.
<NV83A2>
(1) Grip the nail guide and knob with finger.
Press the knob down and swing the nail guide open.
And open the magazine cover.
Knob
Nail guide
(2) Adjust the position of the plate according to the nail
length.
The nail will not feed smoothly if the plate is not
correctly adjusted.
Magazine
Nail holder
NOTE: Before loading nails in the magazine, adjust
the plate. If the magazine cover is forcibly
closed without adjusting the plate correctly,
the nail holder may be damaged.
1 Turn the nail holder about 90 degrees
counterclockwise.
2 Slide in vertical direction possible.
Lift or lower the nail holder to accept different
length nails.
3 Adjust the plate to the nail length reference points
on the magazine cover and turn the nail holder 90
degrees clockwise until you hear "click".
2"
1
3
2
/
" 2
/
"
4
8
1
3
2
/
" 2
/
"
2
4
1
3" 3
/
"
4
Magazine
Magazine cover
Magazine cover
2
1
3
Nail holder
— 13 —
(3) Place the nail coil into the magazine.
Uncoil enough nails to reach the driving hole.
Nails
Magazine
(4) 1 Uncoil enough nails to reach the driving hole.
2 Insert the first nail into the driving hole and the
second nail between the two pawls of the feeder.
3 Fit the nail heads in the guide slot.
Driving hole Guide slot
First nail
2
Nail Guide
2
4 Pulling the nails to the right, swing the nail guide
closed.
(5) Close the magazine cover first and swing the nail
guide closed.
(6) Lock the knob correctly.
Knob
Nail guide
NOTE: Be careful not to deform the collated wires and not
to disengage the nails with the guide surface.
Otherwise, the nail guide will not close correctly.
English
Nail holder
3
4
1
Guide surface
Feeder
Magazine cover
Tabla de contenido
