Exhaust System Requirements - Haier RDE350AW Manual Para El Usuario

Gas Supply Line
• The gas supply line should be ½" (1.3 cm) pipe and must have an individual
manual shut-o valve installed within 6 ft. (183 cm) of the dryer in accordance
with the National Fuel Gas Code, ANSI Z223.1/NFPA 54, or in Canada with the
Natural Gas and Propane Installation Code, B149.1.
• The shut-o valve should be easy to reach for opening and closing.
• A " NPT minimum plugged tapping must be installed immediately upstream of
the shut-o valve. This tting is used to check the gas pressure.
• The supply line should terminate with a
¹⁄₂" NPT Gas Supply Line
Gas Shut-O Valve
¹⁄₈" NPT Minimum Plugged Tapping
" NPT Flare Adapter Fitting

EXHAUST SYSTEM REQUIREMENTS

This section describes the requirements for a safe and efficient exhaust
system. Failure to follow these instructions can result in poor dryer
performance, damage to the dryer, and a re hazard.
DUCTING
• If your current exhaust system is constructed of plastic or metal foil exible
ducting, replace it with rigid metal ducting.
• Use only 4" (10.2 cm) diameter rigid metal ducting.
• When making turns in the ductwork, use 45° elbows rather than 90° elbows. This
provides better air ow and can reduce the accumulation of lint in the exhaust
system.
WARNING
90° - Good
" NPT are adapter tting.
B
A
45° - Better
C
D
11