Stihl MS 201 TC-M Manual De Instrucciones página 33

As soon as the engine runs
1
2
Press down trigger lockout (1) and
N
the pull the throttle trigger (2) at the
same time – the Master Control
lever (3) moves to the run
position (F) and the engine settles
down to idling speed.
Pull the hand guard back towards
N
the front handle.
The chain brake is now disengaged –
your saw is ready for operation.
MS 201 TC-M
NOTICE
Always disengage chain brake before
accelerating the engine. High revs with
the chain brake engaged (chain locked)
will quickly damage the clutch and chain
brake.
At very low outside temperatures
Change over to winter operation if
3 N
necessary – see "Winter Operation".
Stopping the Engine
Move the Master Control lever in the
N
direction of STOP or † – when
released, the Master Control lever
springs back to the normal run
position F.
If engine does not start
Check that all settings are correct.
N
Check that there is fuel in the tank
N
and refuel if necessary.
Check that the spark plug boot is
N
properly connected.
Repeat the starting procedure.
N
or:
It is possible that the fuel-air mixture in
the combustion chamber is over-rich
and has flooded the engine.
Remove the spark plug – see
N
"Spark Plug".
Dry the spark plug.
N
Hold the saw on the ground.
N
Push the Master Control lever as far
N
as stop in direction of STOP or †
and hold it there.
WARNING
An ignition spark may occur if the Master
Control lever is not held against STOP
or †.
Operate the rewind starter several
N
times.
Release the Master Control lever – it
N
springs back to the run position F.
Install the spark plug – see "Spark
N
Plug".
Hold and start your saw as
N
described.
English
31