Medisana 51085 Instrucciones De Manejo página 34

GB
4 Operation
28
On the display, you can see
measurement.
2. Next, the sleeve
measurement has been reached. Alternatively, you can create this pressure
manually by pressing and holding the START button
has automatically reached a pressure of at least 30 mmHg. When you think
that the device has reached the ideal starting pressure for a measurement,
release the START button
cally.
3. The measuring process begins automatically when inflation is complete by
releasing the pressure built up in the cuff. The display shows the current
pressure in the cuff.
4. Initially, deflation occurs at a constant speed. The pulse symbol
appears on the display. As soon as the pulse can be determined, deflation
is synchronised with the beating of the heart until the measurement ends.
The device beeps for each heartbeat during this procedure, if you did not
switch off the beep function beforehand. At the same time, the pulse
symbol flashes.
5. The first measurement ends when the pressure has been completely
discharged from the sleeve during a 15 second countdown. The count-
down symbol flashes during this process. Beeps sound during the last 5
seconds.
6. Instead of " 1 ", the display now shows " 2 " for the second measurement.
The second measurement proceeds in the same way as the first (see points
2 - 5).
7. Instead of " 2 ", the display now shows " 3 " for the third measurement.
The third measurement proceeds in the same way as the first (see points
2 - 4).
8. Once the 3MAM measurement has been taken, the sleeve suddenly
de-flates and a longer beep sounds.
9. The measured values
with the WHO blood pressure bar display
beep sounds.
10. If the unit detects an arrhythmia during the measuring process, the
arrhythmia symbol
displayed. You may also hear 8 short beeps; these warn the user of an
irregular heartbeat.
11. If you do not press any buttons for approx. 1 minute, the device
automatically switches to standby mode.
NOTE
When the device is used, the errors Err 1, 2, 3, 5, 6 can occur in
the integrated circuit. Err 6 can only occur in 3MAM mode.
In 3MAM mode, errors Err 1, 2, 3, 5 do not cause the
measurement to be cancelled, unless they occur twice in
succession. The error display is always accompanied by 3 short
beeps.
(average) and " 1 " for the first
automatically inflates until the pressure required for a
. The increasing pressure is displayed numeri-
, and are shown on the display, together
will flash eight times while the reading is
after the device
. At the same time, a longer