Roger CTRL Instrucciones Y Advertencias Para El Instalador página 79

• If the motor calibration procedure is successful, the message
• To lock the barrier again
AGILIK-KB-BIONIK4HP-BIONIK6-BIONIK8. Turn the key clockwise by two full turns.
BIONIK4. Close the release cover and turn the key.
• The acquisition procedure now starts. The message
at low speed.
•
• The barrier closes until it reaches the barrier closed mechanical stop.
If the acquisition procedure is completed successfully, the display enters the command and safety device state display mode.
•
• .
For more information, see chapter 16 "Alarms and faults".
The correct self-learning procedure of the barrier in STANDARD and MASTER/SLAVE mode requires that
towards closing, check again the correct position of the barrier opening and then set again the value of
parameter .
For connection and wiring operation consider:
• Wiring mains power cable to the MASTER barrier
• RS485 bus connection wiring: check the correspondence of the cables that must connect the LNA
MASTER terminal with the LNA SLAVE terminal, similarly for the LNB MASTER and SLAVE terminals
• Always check that the ST (STOP) and COM inputs are jumpered (if no STOP button is installed, N.C. contact)
• the parameters concerning the functionality of the central unit are managed exclusively by the MASTER central
unit which automatically passes them to the SLAVE central unit. Only parameters
the SLAVE control unit
is shown on the display and the barrier starts opening
, , and must be set on
79