Connecting To Power Supply; Extension Cord; Strain Relief - Stihl HSE 61 Manual De Instrucciones

4 Connecting to Power Supply

To extend your reach, hold the control handle
with one hand and operate the auxiliary switch at
the rear of the control handle with the other
hand.
4 Connecting to Power Sup‐
ply
The voltage and frequency of the machine (see
rating plate) must match the voltage and fre‐
quency of the power connection.
The minimum fuse protection of the power con‐
nection must comply with the specifications – see
"Specifications".
The machine must be connected to the power
supply via an earth-leakage circuit breaker to dis‐
connect the power supply if the differential cur‐
rent to earth exceeds 30 mA.
The power connection must correspond to
IEC 60364 and relevant national regulations.
4.1

Extension cord

The design of the extension cord must at least
fulfill the same features as the connecting cord
on the machine. Observe the design marking
(type designation) on the connecting cord.
The cores in the cord must have the following
minimum cross-section depending on the mains
voltage and cord length.
Cord length
220 V – 240 V:
Up to 20 m
20 m to 50 m
100 V – 127 V:
Up to 10 m
10 m to 30 m
0458-279-9921-E
Minimum cross-section
2
1.5 mm
2
2.5 mm
2
AWG 14 / 2.0 mm
2
AWG 12 / 3.5 mm
1
► Insert the plug (1) into the extension cord cou‐
pling (2).
4.2

Strain Relief

The strain relief (cord retainer) protects the con‐
necting cord against damage.
► Make a loop (3) in the extension cord.
► Pass the loop (3) through the opening (4).
English
2
5
4
3
25