Idiomas disponibles
Idiomas disponibles
Air change
To use the air change function press button "P1" for approx. 3 seconds until "24" appears on the display. The cookerhood runs at
first speed for 5 minutes every 25 minutes for a maximum of 24 hours. When the cookerhood extracts air in this mode (5 minutes) the
numbers "24" flash on the display otherwise they remain fixed. To disable the exchange of air, simply press the "P1". At any time by
pressing "P3" function is disabled.
Activating Adjustable Delayed Automatic Shutdown
With the cookerhood on select the required extraction speed and press button P3 (PIU') for approximately 3 seconds until the letters
"AU" appear on the display and select the required operating time 5-10-15 minutes using buttons P3 and P4.
After having selected the time, after 10 seconds the letters "AU" and selected cookerhood speed flash alternately.
Filter prompt
Aluminium grease filter
After every 30 hours of operation when the cookerhood is turned off, the letters "GF" appear on the display for 30 seconds this prompt
is to remind the user the aluminium grease filters require cleaning. To reset the timer to zero and with the cookerhood off press button
"P4" (MENO) for more than 3 seconds. If the timer is not reset when the cookerhood is turned on again the cleaning prompt will come
up on the display.
Active carbon filter
After every 120 hours of operation when the cookerhood is turned off, the letters "CF" appear on the display for 30 seconds this prompt
is to remind the user to replace the active carbon filter and to clean the aluminium grease filter. To reset the timer to zero and with the
cookerhood off press button "P4" (MENO) for more than 3 seconds. If the timer is not reset when the cookerhood is turned on again the
cleaning prompt will come up on the display.
Always disconnect the hood from the mains before carrying out any maintenance or cleaning operation.
Particular attention should be paid to the metallic anti-grease filters that are designed to trap particles of fat contained in the fumes. The
metallic anti-grease filters must be washed at least once a month with detergent in hot water (or in the dish-washer).
ATTENTION: the grease collected in the filters can easily catch fire and it is therefore extremely important to clean the metallic filters on a
regular basis as per instructions.
The activated charcoal filters are designed to collect unpleasant odours in the cooking fumes. The air is then released purified in the
environment. The charcoal filters must not be washed, but replaced 2 or 3 times a year, depending on how much the hood is used. New
filters are to be requested directly to the manufacturer.
In order to replace the activated charcoal filters, turn the filters until they unfasten from aspirator.
Invert the operation in order to install the new charcoal filters.
In order to remove the remaining glue or any impurity, the cooker hood must be cleaned immediately after installation and after having
removed the protective film.
The cooker hood must be cleaned frequently both internally and externally (at least once a month).
Do not let dirt gather on the inner and outer surfaces of the hood.
To clean the exterior of the hood do not use either acid or basic products, or abrasive sponges.
Clean the hood with a sponge dampen in warm water and a little quantity of neutral detergent (for example dishwasher detergent), in
order to remove possible particles of grease.
Rinse with a damp cloth, removing all the detergent carefully, following the satin finish direction on the steel surface.
Drying is very important, especially in areas where water is particularly hard and leaves limestone.
The present instruction manual is an integral part of the appliance itself, therefore it must be carefully kept and ALWAYS accompany it, even
in case of its assignment to another owner or user or in case the cooker hood is moved to another installation plant.
Any eventual adjustment to the electrical system, which may be necessary to install the cooker hood, must be carried out only by competent
people. Any repair carried out by no competent people may cause damages. For any repair or needed technical action make reference to
a Technical Assistance Center, which is authorized to carry out the replacement of the spare parts.
Always make sure that all the electrical parts (lights, exhaustion unit) are disconnected when the appliance is not in use.
By storms take off the main switch of the house electrical system.
The using of the cooker hood must not be other than the use of exhausting units for cooking damps on domestic kitchens. The manufacturer
does not accept any liability for damages caused by people, animals or things, by installation and maintenance mistakes or by any
illegitimate use.
Make sure that the voltage (V) and the frequency (Hz) ratings indicated on the plate inside the cooker hood correspond to the ones available
in the installation place.
We remind that the use of products functioning with electrical energy implies the observance of some essential security rules, as follows:
• This equipment is not intended for people (children included) with reduced mental or motor capacities, with lack of experience or
knowledge, unless they are supervised or unless a person responsible for their security, gives them instructions regarding the use of the
equipment. Children must be supervised in order to be sure that they do not play with the equipment.
• Any cleaning action is forbidden if the appliance hasn't been disconnected from the main power supply and if the main switch of the house
electrical system is not off. If cleaning is not carried out according to these instructions, a fire may break out.
• Do not pull, take off or twist the cable coming out from the appliance, even though this has been disconnected from the main power supply.
• Do not sprinkle or throw any water directly on the appliance.
• Do not stick any sharp tool inside the exhausting holes and into the air discharge.
• Do not take out the filters in order to reach the internal sides of the appliance in case the main switch of the house electrical system is not off.
• Do not singe or flambé directly underneath the cooker hood. Take particular care when frying to ensure that the oil does not catch fire.
CAUTION: Accessible parts may become hot when used with cooking appliances.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a
hazard.
6
All manuals and user guides at all-guides.com
MAINTENANCE
WARNINGS
