Fujitsu UTY-RSK Serie Manual De Operación página 2

START / STOP
Each press of the " " button alternates operation and stop.
When operating, operation lamp (green)
FAN SPEED
Press the " " button to select the fan speed while in
operation.
Fan speed display
NOTES
(AUTO) (HIGH)
(Select the fan speed
automatically.)
OPERATION MODE
Press " " button to select the operation mode while in
operation.
NOTES
*
(AUTO) (COOL) (DRY)
* A heat pump model that is not set up as an Administrative
Indoor Unit cannot operate in the AUTO modes.
** FAN cannot be selected for a heat pump model.
Refer to details in the Administrative Indoor Unit OPERATING TIPS.
• If the priority mode is set to "Priority on Administrative
Indoor Unit", the operating mode of other indoor units
except Administrative Indoor Unit will be controlled by an
Administrative Indoor Unit.
• If the operating mode of Administrative Indoor Unit is
set to "AUTO", "AUTO" is displayed in addition to the
display of current operating mode on other wired remote
controllers except Administrative Indoor Unit. In this
case, operation of other indoor units is controlled by the
Administrative Indoor Unit.
Ex. : When operating mode of the Administrative Indoor Unit is set
to "AUTO" while air conditioning setting. (The indication on
other wired remote controllers except
Administrative Indoor Unit).
When Administrative Indoor
Unit is set to "AUTO".
9371069029-03_OM_en.indd 2
Instructions related to heating are applicable to "HEATING PUMP MODELS" and "HEAT RECOVERY
MODELS" only.
will light up.
(MED) (LOW)
**
(FAN) (HEAT)
ERROR CODE DISPLAY
If an error occurs, the following display will be shown.
(" " will appear in the set room temperature display.)
If " " is displayed, immediately contact authorized
service personnel. Do not used the operation as
shown to the right if an error has occurred.
Occurrence of an error is indicated by the blinking of
operation lamp.
OPERATION
NOTES
(1) When is displayed, there are functions for which settings cannot be made.
When a button is pushed to change a restricted setting,
(2) When is displayed, some operation are restricted. In such case, contact the administrator.
(3) During Automatic Defrosting operation and Oil Recovery operation,
displayed on the remote controller.
(4) • When " " or " " is indicated on the temperature display, it means under maintenance.
• When " " is indicated on the temperature display, anti freeze function is activated.
However, this function cannot be operated by the remote controller.
(5) Preset values are displayed when the "
"
while stopping.
(6) Mode indication blinks when inoperative setting of indoor unit is made.
(7) Blinking of the fan speed display means the timing for filter
cleaning of the indoor unit.
To erase indication, press the "
TEMPERATURE
Press the "
temperature while in operation.
Temperature setting range
AUTO • • • • • • • • • • • • • • 18 to 30°C
HEAT • • • • • • • • • • • • • • 10 to 30°C
COOL/DRY • • • • • • • • • • 18 to 30°C
The temperature setting should be considered a standard value,
and may differ somewhat from the actual room temperature.
will flash.
will be
" button or " " button, the " " button is pressed
" button for more than 2 seconds.
" button or " " button to set the room
NOTES
Faulty unit No.
(0-15, C0)
Ex. Error code display
" button, the
Error code
5/28/2009 2:27:52 PM