Engine Stop; Using The Machine - Garland ROLL & COMB 602 QG-V21 Manual De Instrucciones

6. Tighten the safety lever (1)
7. Place yourself behind the mower and pull the
Starter rope until the engine starts.

6.5.2.3. ENGINE STOP

1. Release the safety lever (1)
2. Set the ON / OFF switch (12) to the OFF (stop)
position.
3. Close the fuel cock.
6.5.3. CHECK POINTS AFTER START-UP
It is important to pay attention to the possible
individual parts or and the temperature of the
machine. If you detect any anomaly in the machine
immediately stop and check it carefully.
In case of any malfunction or problem take the
machine to a service technician to be repaired.
Under no circumstances must you continue to use the
machine if the operation does not seem appropriate.
Do not use the machine if it is damaged or improperly
adjusted.

7. USING THE MACHINE

Use this machine only for its intended uses. Using
this machine for any other use is dangerous and may
cause damage to the user and / or the machine.
Do not put your hands or feet under the machine.
Keep all parts of the body away from the brush when
the machine is running.
Before starting the machine, make sure that the brush
is not in contact with any object.
Do not start the machine in a room or
enclosure. The exhaust gases and fuel and
oil vapors contain carbon monoxide and
harmful chemicals. In case of a concentration of gases
produced by poor ventilation, remove all that impedes
the flow of clean air to improve ventilation from the
work area and not return to work in the area unless
you have properly ventilated area and have clear that
ventilation is sufficient so that does not happen this
concentration again.
If you slip or lose your balance or fall, release the
breaker bar immediately.
Do not rely solely on the safety features of this
machine.
Do not use this machine if you are fatigued, ill, have
taken medication, narcotics, or alcohol.
Do not use this machine at night, in fog, or with
reduced visibility that makes it difficult to see the work
area.
Lack of rest and fatigue can lead to accidents or
damage.
Never leave this machine unattended.
Do not allow anyone to enter the work area. This work
perimeter must be 15 meters and it is a dangerous
area.
Clean the work area and remove all obstacles that
could cause accidents. Always set the machine on a
flat and stable surface.
Do not use accessories in this machine except those
recommended by our company, as their use could
cause severe damage to the user, to people near the
machine and to the machine itself.
39/100
English