Amway eSpring Manual Del Usuario página 6

AT TACH IN G T UBIN G TO WATER P U R IF IER AND CHEC KI NG FO R L EAKS
**MAKE SURE THE UNIT IS NOT PLUGGED INTO AN ELECTRICAL OUTLET.
1. Position the eSpring TM
Fig. 11A
Water Purifi er in a
desired location where
the tubing from the fau-
cet reaches the Water
Purifi er and the Power
Adapter reaches an
outlet with continuous
power (Fig. 11A).
2. Remove the Top Shroud (Fig. 12A).
3. Remove the Electronic Module
(Fig. 13A).
4. If the tubing is too long, use a
sharp knife to cut the tubes at the
same length where they are NOT
BONDED TOGETHER. Make sure to
make a straight cut to form a fl at
end on the tubes (Fig. 14A).
4
Fig. 12A
Fig. 13A
Fig. 14A
5. Lay the large tube on top of
the diagram and the small
tube on the bottom of the
diagram and use a pen to
mark a line across each tube
at the arrows (Fig. 15A).
6. Push tubing supports into their
respective tubes (Fig. 16A).
7. Insert each tube into the proper
locations on the Bracket until you
meet the marks or the marks
disappear (Fig. 17A & 18A).
NOTE: You will feel resistance before the
tube is fully installed.
Fig. 15A
3 ⁄ "( )
4
⁄ "( )
5
8
Fig. 16A
Fig. 17A
Fig. 18A