To Use The Save ™ Function; Automatic Restart; To Cut Grass Without A Grass Catcher Or Mulch Plug Attached; Maintenance - Husqvarna LC 142i Manual De Usuario

4. Stay behind the product.
5. Loosen the start inhibitor. (Fig. 17)
6. Push the motor brake handle in the direction of the
handlebar. (Fig. 34)
To use the drive on the wheels (LC
142iS)
• Push the drive bail in the direction of the handlebar.
(Fig. 35)
• Release the drive bail to disengage the drive, for
example when you go near an obstacle.
• Before you pull the product rearward, disengage the
drive and push the product forward approximately 10
cm.
To use the SavE
The product has a battery saving function (SavE
gives longer operation time.
™
• Push the SavE button to position 1 to start the
function. (Fig. 36)
™
• Push the SavE button to position 0 to stop the
function.
Note:
™
The SavE function stops automatically if the
ground conditions make it necessary to have a higher
™
output. The SavE function starts automatically again
when the ground conditions let it.
High load function
When the product cuts long or wet grass, the motor
automatically increases rpm. The motor goes back to
standard mode when high load is not necessary.

Automatic restart

During operation, the blade and motor can temporarily
stop because of obstacles such as grass blockage
below the cutting cover. If this occurs and you keep the
motor brake handle pushed down, the product tries to
restart automatically. If the product does not restart in 5
seconds, it can be necessary to clean below the cutting
To clean the product on page 16 .
cover. Refer to
WARNING:
cutting cover, release the motor brake
handle, turn the safety key to 0, remove the
Introduction
WARNING:
maintenance, you must read and
understand the safety chapter.
1692 - 002 - 26.11.2021
™
function
Before a check of the
Before you do
To stop the product
1. Release the motor brake handle to stop the motor.
(Fig. 37)
2. Open the battery lid and turn the safety key to 0.
(Fig. 38)
3. To remove the battery, push the 2 release buttons
and pull out the battery. (Fig. 39)
4. Charge the battery if it is weak. For more
™
) that
information, refer to
14 .
To get a good result
• Always use a sharp blade. A blunt blade gives an
irregular result and the cut surface of the grass
becomes yellow. A sharp blade also uses less
energy than a blunt blade.
• Do not cut more than ⅓ of the length of the grass.
Cut first with the cutting height set high. Examine the
result and lower the cutting height to an applicable
level. If the grass is very long, drive slowly and cut 2
times if necessary.
• Cut in different directions each time to prevent
stripes in the lawn.
• Keep the cutting cover clean. Buildup from grass and
dirt on the inner side of the cutting cover can
decrease the cutting result. Refer to
product on page 16 .
To cut grass without a grass catcher or
mulch plug attached
• Lift up the rear cover and remove the grass catcher.
• If a mulch plug and a mulch blade are attached,
remove them.
• Close the rear cover before you operate the product.
When you operate the product, the cut grass discharges
below the rear cover.

Maintenance

For all servicing and repair work on the product, special
training is necessary. We guarantee the availability of
professional repairs and servicing. If your dealer is not a
service agent, speak to them for information about the
nearest service agent.
For more detailed information, refer to
www.husqvarna.com.
battery and wait at minimum 5 seconds.
There is a risk of injury if the obstacle is
removed and the product accidentally starts.
WARNING:
Turn the safety key to 0
before you let the product out of view.
To charge the battery on page
To clean the
15