Fitting/Changing Accessory Tools (Fig. A); Installing The Dust Extraction System - Parkside PWBS 180 B3 Traducción Del Manual De Instrucciones Original

Fitting/changing accessory tools
(Fig. A)
WARNING!
► Press the spindle locking button
when the grinding spindle
Otherwise the appliance may be damaged.
NOTE
■ The carbide grinding head
removing formwork transitions on exposed
concrete, residual concrete on formwork
boards or adhesive residues on tiles.
■ Only use carbide sanding
heads
surface.
♦ Clean the sanding spindle
be mounted.
♦ Press the spindle locking button
and release the accessory tool.
♦ To fit the accessory tool, place the mounting
flange onto the sanding spindle
♦ Place the desired accessory tool onto the
sanding spindle
♦ Screw the clamping nut
the two-hole assembly spanner
NOTE
► Make sure that the collar of the clamping
nut is facing outwards.
PWBS 180 B3
only
is at a standstill.
is suitable for
with an even sanding
and all parts to
to clamp
.
.
and tighten it with
.
≤ 3,2 mm

Installing the dust extraction system

Dust from materials such as lead-based paints,
some types of wood, minerals and metal can be
harmful to health. Touching or inhaling the dusts
may cause allergic reactions and/or respiratory
illnesses of the user or people in the vicinity.
Certain dusts such as oak or beech dust are consid-
ered carcinogenic, especially in combination with
wood treatment additives (chromate, wood preserv-
atives). Materials containing asbestos may only be
worked on by specialists.
■ Always use dust extraction.
■ Operate the power tool either with the dust
bag or connect an approved dust and chip
extraction device.
■ Ensure that your workplace is adequately
ventilated.
■ We recommend you wear a respirator with
a class P2 filter.
■ Avoid kinking the suction hose
Observe the applicable regulations in your country
regarding the materials to be worked.
♦ Plug the inlet side of the suction hose
the extraction nozzle
♦ Pull the mouthpiece
Open the zip on the dust bag
the outlet end of the suction hose
corresponding opening on the dust bag
Reconnect the mouthpiece
hose from the inside. Close the zip on the
dust bag
18a
♦ Proceed in the reverse order to dismantle the
suction hose
12
.
.
off the suction hose
19a
. Now plug
18a
to the suction
19a
.
.
GB │ IE
onto
.
into the
.
│ 9 ■