Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Front Wishbone Bush Tool | for VAG
COMPONENTS
1 Removal adaptor
2 Removal sleeve
3 Mounting adaptor (bushing side)
4 Mounting adaptor (wishbone side)
5 Nut
6 Threaded bolt
ATTENTION
Read the operating instructions and all safety instructions contained therein carefully before using the
product. Use the product correctly, with care and only according to the intended purpose. Non-
compliance of the safety instructions may lead to damage, personal injury and to termination of the
warranty. Keep these instructions in a safe and dry location for future reference. Enclose the
operating instructions when handing over the product to third-parties.
INTENDED USE
This tool set is used for the removal and installation of the rear mounted bush on the front lower
wishbone and can be used without removing the wishbone. The included tools are suitable for
following vehicles: Seat Cordoba III (2003-) / Skoda Fabia (2000-) / VW Polo IV (2002-)
SAFETY INFORMATIONS
• Use the tool only for work it is intended for.
• When lifting the vehicle, always use the lifting points intended by the vehicle manufacturer.
• Before commencing work under the vehicle, always ensure that the vehicle is sufficiently
supported by axle stands or ramps. Put wedges under the wheels and make sure that the
handbrake has been applied.
• When working, ensure for a safe and anti-slip stand.
• When working with this tool set, always wear gloves and safety glasses.
• Make sure that the tool is mounted correctly.
• Do not over tighten or apply excessive force to the spindle as this could otherwise damage the
tool as well as the component.
• The tool is not suitable for air impact wrenches. The use of an air Impact Wrench may lead to
the spindle bearing or other components rupturing. The fragments of the components flying
around may cause injuries.
• Always use a workshop manual for detailed instructions.
• Always grease the spindle thread before using the tool.
• Keep children and unauthorised persons away from the work area.
• Do not let any children play with the tool or its packaging.
• Make sure that the work area is sufficiently illuminated.
• Keep the work area clean, organised, dry and free from other materials.
• Keep this tool out of reach of children.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
BGS 8589
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Tabla de contenido
