Commissioning; Securing - IKA EUROSTAR digital Instrucciones De Manejo

- PC 5.1 Adaptor IKA-Control
For appliance types EUROSTAR power an adaptor cable is
available as an accessory. It splits up analogue and serial sig-
nals. The analogue output signals are placed on a 7-pin connec-
tor in accordance with the NAMUR recommendation, the seri-
al signals on a 9-pin Sub-D connector (RS 232 C).
(2) Torque
(3) Analog GND
(5) Speed
- PC 1.2 Adaptor
This adaptor is required to connect the 9pin connector to an 8-
way serial interface (25-pin plug).
- PC 2.1 Cable
This cable is required to connect the 9-pin connector to a PC.
- AK 2.1 Cable
This cable is required to connect the 7-pin connector to a chart
recorder (4mm pin plug).
- AK 2.2 Cable
This cable is required to connect the 15-pin connector to a
chart recorder (4mm pin plug).

Commissioning

For correct use, the stirrer appliance must be fixed with a cross
sleeve (e.g. R182; R270) to a stable stand (e.g. R1826 or R
2723).
Accessories must be assembled according to the following
assembly instructions:
24
(Fig. 9)

Securing

Attaching the extension arm to the overhead stirrer
Please refer to assembly diagram
Ensure that the extension is fitted securely.
Vibration may cause the screw to become loose. It is therefo-
re necessary for safe use to occasionally check that the exten-
(2) R x D
(3) T x D sion arm is attached securely. Tighten the hexagon bolt as if
(5) RS 232 GND
required.
(7) RTS
Attaching the stirrer to the stand
(8) CTS
Please refer to assembly diagram
Attach the cross sleeve (K) to the upright of the stand (I).
Attach the extension arm (L) to the side of the cross sleeve not
in use, with the opening facing upwards.
(Fig. 10) Tighten both clamping bolts (M) firmly once the desired positi-
on for the stirring procedure has been adjusted correctly.
Check that the stirrer is held in position firmly prior to
each use and also at regular intervals. The position of
the stirrer must only be adjusted when the equipment
is stationary and the power supply is disconnected.
Attaching a stirring tool using the chuck
Please refer to assembly diagram
Applies to all EUROSTAR and EUROSTAR power stirring devi-
ces with chucks
Slide the stirring tool (G) into the chuck (F). Tighten the chuck
firmly using the chuck key (H).
Attaching a stirring tool using the conical attachment
Please refer to assembly diagram
Applies only to EUROSTAR power control visc 6000 stirrers
Slide the R6000 precision shaft (U) into the conical attachment
on the output shaft (R). Tighten the retaining nut (S) using a
hook spanner and a single open-end spanner.
The stirring tool must only be changed when the
equipment is stationary and the power supply is dis-
connected.
(Fig. 11)
(Fig. 12)
(Fig. 13)
(Fig. 14)
EUSTAR0707