Switching On The Device; Output Shaft; Maintenance - IKA EUROSTAR digital Instrucciones De Manejo

Ocultar thumbs Ver también para EUROSTAR digital:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 42
To fit the stirring device (T), hold the output shaft/precision
shaft stationary using a single open-end spanner. The stirring
device can be tightened in place with a second single open-end
spanner, using the area on the stirring device provided for this
purpose.
Check that the stirring tool is held in position securely
prior to each use and also at regular intervals. The stir-
ring tool must only be changed when the equipment
is stationary and the power supply is disconnected.
Attaching the stirring shaft protector
Please refer to assembly diagram
Use a stirring shaft protector (O), e.g. R301, to provide protec-
tion against injury when working with the equipment.
Use the bolts (P) to attach the plastic half-shell pieces to the
stirrer (N), as shown in Figure 15. The screw (Q) can be used
to adjust the length of the stirring shaft protector.
Check that the stirring shaft protector is held in positi-
on securely prior to each use and also at regular inter-
vals. The position of the stirring shaft protector must
only be adjusted when the equipment is stationary
and the power supply is disconnected.

Switching on the device

Check whether the voltage given on the type plate corre-
sponds to the available mains voltage. The socket used must
be earthed (fitted with earth contact). If these conditions have
been met, the appliance is ready to oprate when the mains is
plugged in. If these conditions are not met, safe operation is
not guaranteedand the machine could be damaged.
After switching on the mains switch (O) in position 'I', the
appliance carries out a self-test. Afterwards,the output shaft
starts to rotate. A green control light (E) signals the operating
status 'ON'.
EUSTAR0707
During commissioning of the appliance the output shaft starts
to run at the last speed set. Therefore check the setting of the
control knob. Also ensure that the speed set is suitable for the
test texture selected. If in doubt, set the speed knob (B) to the
lowest speed (left hand position).

Output shaft

The clamping chuck and output shaft permit all standard com-
mercial stirrer tools up to 10mm diameter to be gripped and
(Fig. 15)
screwed in. The opening on the top side of the housing is clo-
sed with a slotted rubber diagraphm. It is, however, possible
for stirring shafts to push out over the top edge of the housing
eg during change of container.
If the stirring shaft cover is removed while the stirrer is statio-
nary, then the rubber membrane must be pushed back into the
opening of the housing so that this is properly closed. This is
the only way to ensure that working with the unit is safe and
that media cannot enter the equipment.
Please see section "Safety instructions"!

Maintenance

Only use cleansing agents which have been recommended by IKA
Use to remove:
Dyes
Construction materials water containing tenside/ isopropyl alcohol
Cosmetics
The appliance is maintenance-free.
Cleaning
isopropyl alcohol
water containing tenside/ isopropyl alcohol
25
Tabla de contenido
loading

Tabla de contenido