Safety Instructions - IKA EUROSTAR digital Instrucciones De Manejo

Contents
CE - Declaration of conformity
Safety instructions
Correct use
Unpacking
Motor protection, safety devices
Speed - normal operations
Speed - overload operation
Torque indicator
Interfaces and outputs
Commissioning
Securing - extension arm
- stirrer
- stirrer tools
- stirrer shaft protection device
Switching on the device
Output shaft
Maintenance
Warranty
Accessories
Technical data
Permitted IKA stirrer tools

Safety instructions

• Read the operating instructions in full before starting up
and follow the safety instructions.
• Keep the operating instructions in a place where they can be
accessed by everyone.
• Ensure that only trained staff work with the appliance.
• Follow the safety instructions, guidelines, occupational health
and safety and accident prevention regulations.
• The voltage stated on the nameplate must correspond to the
mains voltage.
18
• Socket must be earthed (protective ground contact).
• Wear your personal protective equipment in accordance with the
hazard category of the medium to be processed. Otherwise
Page
here is a risk of:
2
- splashing liquids
18
- projectile parts
19
- body parts, hair, clothing and jewellery getting caught.
19
• Set up the appliance in a spacious area on an even, stable, clean,
19
non-slip, dry and fireproof surface.
20
• The feet of the appliance must be clean and undamaged.
21
• Position the knob (B) at the left stop before starting up. Gradually
21
increase the speed.
22
• Reduce the speed if
24
- the medium splashes out of the vessel because the speed is
24
too high
- the appliance is not running smoothly
- the appliance begins to move around because of dynamic forces.
• Firmly secure the accessories and vessels in place, otherwise
25
shaking vessels could be damaged or projected out.
25
• Check the appliance and accessories beforehand for damage
25
each time you use them. Do not use damaged components.
26
• The equipment is not suitable for manual operation.
26
• Beware of the risk of
27
- flammable materials
29
- glass braekage as a result of mechanical shaking power
There may be dangerous electrostatic activity between the
medium and the output shaft
• Only process media that will not react dangerously to the
extra energy produced through processing. This also applies
to any extra energie produced in other ways, e.g. through ligh
irradiation.
• Do not operate the appliance in explosive atmospheres,
with hazardous substances or under water.
• Safe operation is only guaranteed with the accessories desci
bed in the "Accessories" chapter.
• Always disconnect the plug before fitting accessories.
• The appliance starts up again automatcally following a cut in
the power supply.
EN
EUSTAR0707