Mowing Blade Maintenance; Maintenance Interval; Maintenance Operations - Viking MR 4082 Manual De Instrucciones

● Select the lowest cutting level.
Push discharge chute (1) in to the stop and
position it over the discharge opening in
the mowing deck.
Screw in retaining nut (2) and tighten.

14.7 Mowing blade maintenance

Risk of injury!
Always wear gloves. If you do not
have the necessary expertise or
auxiliary equipment, please always
contact a specialist dealer. (VIKING
recommends VIKING specialist
dealers).
VIKING recommends the use of
original VIKING spare parts.
Never touch the mowing blade
before it has come to a standstill.
Always set down the mowing deck
on a non-slip surface.

Maintenance interval:

Every 25 operating hours

Maintenance operations:

● Check the mowing blade wear limits:
96
● Sharpen the mowing blade if
necessary.
If mowing results deteriorate, the
mowing blade should be sharpened.
Checking the mowing blade wear limits
Risk of injury!
A worn mowing blade may break off
and cause serious injuries. The
instructions for blade maintenance
must therefore always be observed.
Mowing blades are subject to
differing degrees of wear
depending on the location and
duration of use. If you use the
machine on sandy ground or use it
frequently under dry conditions, the
mowing blade will be subjected to
greater loads and will wear more
quickly than normal.
Caution!
Always replace the blade
fastening screw and the retaining
washer when replacing the mowing
blade.
VIKING recommends removing the
mowing deck if the wear limits need
to be checked.
If a suitable lifting platform is
available, the mowing blade wear
limits can also be checked with the
mowing deck installed.
● Remove the mowing deck. (
● Carefully clean the mowing deck and
mowing blades.
Placing the mowing deck in safe
position for checks:
Lean mowing deck (1) against a wall and
secure against slipping with the foot.
Blade thickness:
13.1)
Check the thickness of mowing blade (1)
at several points using a slide calliper. The
mowing blade must meet the minimum
blade thickness A at each individual point.
A > 2,5 mm
0478 193 9902 A - EN