Samsung DV52J8700E Serie Manual Del Usuario página 22

Installation
STEP 4 Connect the water hose
The dryer must be connected to a cold water tap using the provided water hoses.
If the Y connector cannot be directly connected to the cold water tap, use the short hose
as shown on the following page.
22 English
DV8000J-03170S-02_EN-US_150511.indd 22
All manuals and user guides at all-guides.com
1. Close the cold water tap. If you have a
2. Connect the straight end of the water
3. Using pliers, tighten the coupling an
4. Connect the angled end of the water
5. Using pliers, tighten the coupling an
6. If you detached the cold water hose
7. Open the cold water tap, and then check
washer cold water hose attached to the
cold water faucet, unscrew and remove
the hose. Then, connect the female end
of the Y connector to the cold water
tap.
hose to the Y connector.
additional two-thirds turn. Do not
overtighten because the coupling may
be damaged.
hose to the filling valve at the bottom
of the rear frame. Turn the coupling
manually until it is tight.
additional two-thirds turn. Do not
overtighten because the coupling may
be damaged.
from your washer, attach the hose
to the open end of the Y connector,
tighten the coupling until it is tight,
and then, using a pliers, tighten an
additional two-thirds turn.
for any leaks.
2015/7/7 13:40:43