Black Max BMi2100 Serie Manual Del Operador página 18

WARNING:
While operating and storing, keep at least 3 feet of clear-
ance on all sides of this product, including overhead.
Allow a minimum of 30 minutes of "cool down" time be-
fore storage. Heat created by muffler and exhaust gases
can be hot enough to cause serious burns and/or ignite
combustible objects.
USING THE BATTERY CHARGING CABLE
ASSEMBLY
See Figure 9.
WARNING:
The 12 V DC receptacle is designed to charge vented
wet lead acid batteries only. Other types of batteries may
burst, causing personal injury and damage.
NOTICE:
The 12 V DC receptacle provides continuous charge. Do
not overcharge battery or leave battery unattended. Doing
so may cause damage to the battery.
NOTICE:
Do not use the generator to jump start vehicles. Doing
so could result in damage to the vehicle or it's electrical
components.
 Using the battery clamps, connect the battery charging
cable assembly to the battery terminal. Connect the
red wire to the positive (+) terminal first, then connect
the black wire to the negative (–) terminal. Make sure all
connections are secure.
NOTE: Be careful not to short across the terminals when
installing. Shorting the terminals together can cause
sparks, damage to the battery or generator, or even burns
or explosions.
NOTE: To prevent short circuit, keep away from a metal
surface during clamp connection.
 Connect the battery charging cable assembly to the
12 V DC receptacle.
All manuals and user guides at all-guides.com
OPERATION
 Start the generator.
 The battery will become slightly warm to the touch while
 When batteries become fully charged, disconnect
 Unplug battery charging cable assembly and store for
MOVING THE GENERATOR
See Figure 10.
 Turn off the generator.
 Allow 30 minutes of "cool down" time before storing the
 Turn the On/Off switch to OFF.
 Pull the retractable handle out.
 Facing the back of the generator, grasp the folding handle
 Lift the generator toward you until it balances on the
 Turn around and pull the unit along behind you to the
 Lower the generator until it sits securely on a flat surface.
HIGH ALTITUDE OPERATION
Specific modifications are needed for high-altitude operation
for equipment operating in altitudes greater than 5000 feet
above sea level. Please contact your authorized service cen-
ter for important information regarding these modifications.
Operating this engine without the proper altitude modifica-
tion may increase the engine's emissions and decrease fuel
economy and performance.
Page 14 — English
NOTE: The AC receptacles can be used while the DC
receptacle is in use.
charging. This is normal and does not indicate a problem.
NOTE: Only use battery charging cable assembly to
charge vented wet lead acid batteries.
the battery charging cable assembly from the battery.
Disconnect the negative (black) wire first, then the positive
(red) wire, being careful not to short across the terminals.
Always abide by the safety warnings provided with the
battery.
NOTE: Most batteries will be completely charged after
30 to 120 minutes. However, it is highly recommended
that you refer to your battery manufacturer's instructions
for specific charge times.
later use.
machine.
firmly with one hand.
wheels.
desired location.