Sharpening The Saw Chain - Makita DUC122 Manual De Instrucciones

1
008575
1
008574
Bring the lower guide or tip guide (if equipped) into
contact with the branch to be cut before switching on.
Cutting without bringing the tip guide/lower guide into
contact with the branch may cause the guide bar to
wobble, resulting in injury to operator.
When cutting thick branches, first make a shallow
undercut and then make the finish cut from the top.
1
008576
If you try to cut off thick branches from the bottom, the
branch may close in and pinch the saw chain in the cut.
If you try to cut off thick branches from the top without a
shallow undercut, the branch may splinter.
001742
If you cannot cut the timber right through with a single stroke:
Apply light pressure to the handle and continue sawing
and draw the chain saw back a little; then apply the spike
a little lower and finish the cut by raising the handle.
1. Lower guide
1. Tip guide
2
008634
Carrying tool
1
013647
Always remove the battery cartridge from the tool and
overlap the guide bar with the scabbard before carrying
the tool. Also cover the battery cartridge with the battery
cover.
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before attempting to
perform inspection or maintenance.
Always wear
•
inspection or maintenance.
Never use gasoline, benzine, thinner, alcohol or
•
the like. Discoloration, deformation or cracks may
result.

Sharpening the saw chain

CAUTION:
Always remove the battery cartridge and wear
•
safety gloves when performing work on the saw
chain.
008633
10
1. Battery cartridge
2. Scabbard (chain
cover)
2
gloves when performing any