Test Mode - Ugolini Mini GEL Manual De Servicio

PA07 Lock Keypad.
PA08 Scale representation of temperature.
PA09 Firmware version display circuit board.
PA10 Firmware version power circuit board.
2 SUPER SERVICE MODE – ADJUSTING THE MANUFACTORY PARAMETERS
By switching on the dispenser using the master switch and holding down keys A and H simultaneously, the machine can be started
up in Super Service Mode and make adjusting the manufactory parameters. The dispenser will function normally, but it will be pos-
sible to modify the production parameters and any modifications carried out will be stored in the memory for the next time the dispen-
ser is switched on in normal mode.
For information on how to adjust the production parameters, please refer to the instructions for the operation parameters.
Incorrect adjustment of the Production Parameters may compromise the opera-
tion of the machine.
LIST OF PRODUCTION PARAMETERS
NAME DESCRIPTION
PA11 Ice Cream Production Mode Density
PA12 Ice Cream Production Mode Density Hysteresis
PA13 Ice Cream Production Mode Temperature Hysteresis
PA14 Compressor lockout time OFF
PA15 Electrovalve lockout time OFF
PA16 Time for which the density must remain above the reference value
PA17 Conservation Mode Temperature Hysteresis
PA18 Maximum motor absorption
PA19 Motor cooling time
PA20 Motor protection intervention delay
PA21 Product conservation alarm temperature
PA22 Tap sensor entry activation
PA23 Temperature probe offset
PA24 Number of motor poles
PA25 Motor control proportional P constant
PA26 Motor control integral I constant
PA27 Motor control derivative D constant

3 TEST MODE

When the machine is started up in test mode, it is possible to check the function of individual components by activating them one by
one. The Test Mode is activated by switching on the machine whilst holding down the E key. The display test will be carried out first.
When the A key is pressed, the machine moves on to the control panel test, during which each key should be pressed and the cor-
responding code should appear on the display. Pressing the A and E keys simultaneously then moves the machine on to the outlet
tests, during which the C or D keys can be used to select an individual outlet and the H key can be used to activate and deactivate
the selected outlet. The message "out" followed by the number of the outlet selected will appear on the display, according to the
following table:
out 1 compressor
out 2 geared motor
out 3 defrost fan
out 4 lights circuit board
out 5 valve
IMPORTANT
15
ON...OFF
C...F
Visualisation only
Visualisation only
ADJUSTMENT INTERVAL
1...10
0...1
0...5 °C
0...600 s
0...600 s
0...60 s
0...5 °C
0...100 W
0...600 s
0...60 s
0...10 °C
ON...OFF
?
0...1000
0...1000
0...1000
YES...NO
OFF
C
DEFAULT VALUE
5
0,25
0,5
120
60
1
0,5
90
90
30
4
OFF
0
300
4
0
NO