AEG MBS 30 Turbo Manual De Instrucciones página 23

mounting hardware of the saw will run eccentrically, causing loss of
control.
blade washers and bolt were specially designed for your saw, for
optimum performance and safety of operation.
kickback is a sudden reaction to a pinched, bound or misaligned saw
blade, causing an uncontrolled saw to lift up and out of the workpiece
toward the operator;
when the blade is pinched or bound tightly by the kerf closing down,
the blade stalls and the motor reaction drives the unit rapidly back
toward the operator;
if the blade becomes twisted or misaligned in the cut, the teeth at
the back edge of the blade can dig into the top surface of the wood
causing the blade to climb out of the kerf and jump back toward the
operator.
GB
Kickback is the result of saw misuse and/or incorrect operating procedures or conditions and can be avoided by taking proper
precautions as given below.
Kickback could cause the saw to jump backwards, but kickback forces
can be controlled by the operator, if proper precautions are taken.
Investigate and take corrective actions to eliminate the cause of blade
binding.
If saw blade is binding, it may walk up or kickback from
the workpiece as the saw is restarted.
Large panels tend to sag under their own weight.
Supports must be placed under the panel on both sides, near the line
of cut and near the edge of the panel.
set blades produce narrow kerf causing excessive friction, blade
binding and kickback.
cutting, it may cause binding and kickback.
that can cause kickback.
English
Blades that do not match the
Unsharpened or improperly
If blade adjustment shifts while
The protruding blade may cut objects
If saw is accidentally dropped, lower guard may be
The
bent. Raise the lower guard with the retracting handle and make sure
it moves freely and does not touch the blade or any other part, in all
angles and depths of cut.
damaged parts, gummy deposits, or a build-up of debris.
sawing, the lower guard should operate automatically.
coasting blade will cause the saw to walk backwards, cutting
whatever is in its path. Be aware of the time it takes for the blade to
stop after switch is released.
Please do not use abrasion disks in this machine!
all instructions listed below may result in electric shock, fire and/or
serious injury.
operator from broken wheel fragments and accidental contact with
wheel.
because an accessory can be attached to your power tool, it does not
assure safe operation.
faster than their rated speed can break and fly apart.
cutoff wheels are intended for peripheral grinding, side forces applied
to these wheels may cause them to shatter.
the wheel thus reducing the possibility of wheel breakage.
Incorrectly sized accessories cannot be adequately guarded or
controlled.
Lower guard may operate sluggishly due to
For all other
An unprotected,
Failure to follow
The guard helps to protect
Accessories running
Proper wheel flanges support
Just
Abrasive