Before Use; Placement Precautions; Note About Pinpoint Feet - Teac AP-505 Manual Del Usuario

Before use

V Placement precautions
o Place the unit in a stable location near the audio system that you
will use with it.
o Do not install this unit in a location that could become hot.
This includes places that are exposed to direct sunlight or near
a radiator, heater, stove or other heating equipment. Moreover,
do not place it on top of an amplifier or other equipment that
generates heat. Doing so could cause discoloration, deformation
or malfunction.
Also avoid locations that are subject to vibrations or exposed to
excessive dust, cold or moisture.
o When installing this unit, leave a little space (at least 3 cm or 1")
between it and walls and other devices in order to allow good
heat dissipation.
If you put it in a rack, for example, leave at least 5 cm (2") open
above it and at least 10 cm (4") open behind it. Failure to provide
these gaps could cause heat to build up inside and result in fire.
o You may stack this unit with a PD-501HR, NT-505 or other
501/503/505 series units. However, if heat should cause the pro-
tection circuit to be activated and sound output stops suddenly,
place this unit on top and with sufficient distance between it and
walls and other devices in order to improve heat dissipation.
o Do not place CDs, CD-Rs, cassette tapes, other audio equipment
or other items that are susceptible to heat on top of the unit.
Doing so could damage these items.
o Do not put cloth on top of the unit or place the unit on top of
bedding or thick carpets. Doing so could cause the unit to over-
heat and damage it.
o Do not move the unit during use.
o The voltage supplied to the unit should match the voltage
printed on the bottom of the unit. If you are in any doubt regard-
ing this matter, consult an electrician.
o Do not open the body of the unit as this might result in damage
to the circuitry or cause electric shock. If a foreign object should
get into the unit, contact your dealer.
o When removing the power plug from the wall outlet, always pull
directly on the plug; never yank on the cord.
6

Note about pinpoint feet

High-precision metal pinpoint feet are attached firmly to the bot-
tom plate of this unit.
The stands for these feet are loose, but when the unit is placed in
position, it is supported by these pinpoint feet, which will effectively
disperse vibrations.
Chassis
Foot-stand (metal)
o The included rubber pads are intended to protect the surface
where the unit is placed. Apply them to the bottoms of the
foot-stands.
Pinpoint foot (metal)
Screws that attach
foot-stand