Cleaning And Maintenance - YATO YT-82550 Manual De Usuario

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 50
GB
Painting
First trials of spraying the coating material are recommended to be carried out on the test surface. This will allow avoiding any
damage to working surface.
Make sure that all surfaces that are not to be coated are thoroughly covered. Make sure that the surface to be coated is clean,
dry, degreased and free of dust.
Hold the device straight in a vertical position so that the nozzle outlet stays approximately 20 cm away from the surface being
sprayed.
Displace the gun from side to side or up and down so that it always stays at a constant distance from the surface being sprayed
(V). Begin displacing the gun, then press the trigger in its course. Release the trigger before completing the gun movement (VI).
Displace the gun in a monotonous motion, changes in pace or stopping the gun while spraying will result in an uneven distribution
of coating material.
Avoid tilting the gun both horizontally and vertically (VII). This will result in an uneven distribution of coating material.
Apply a few thin layers of coating material instead of one thick layer.
Before applying the next coat, leave the previous one to be slightly dried, follow the instructions provided with the sprayed agent.

CLEANING AND MAINTENANCE

Warning! Do not use fl ammable materials for cleaning and maintenance.
Immediately after the end of spraying the coating material, unscrew the container and clean it inside and the outside of suction
tube with a thinner intended for a given coating material. Then fi ll the tank with the thinner intended for a given coating material
and start spraying it onto the test surface. Spraying should be stopped as soon as a clean thinner is coming out of the nozzle.
Stop spraying, unplug the power cord from the mains socket, and then disassemble the container, empty the residues of thinner
and dry it.
Unscrew the nozzle fi xing nut and thoroughly clean the spray nozzle and piston, using a soft cloth and a thinner intended for a
given coating material.
Leaving the gun without cleaning will cause the coating material to dry inside the product. This may lead to irreversible gun
damage.
Clean the outside parts of the product with a soft, damp cloth and then wipe them dry.
Note! It is forbidden to clean the gun by directing a stream against it or submerging it in water, thinner or other liquid.
It is forbidden to use sharp objects and/or abrasive cleaning agents used for cleaning the gun.
O R I G I N A L
I N S T R U C T I O N S
13
Tabla de contenido
loading

Tabla de contenido