Smatv Scanning; Reset To Factory Defaults - Samsung DSB-A200C Instrucciones De Uso

2/27/04 3:22 PM Page 20
OPERATING THE RECEIVER
al Scanning
w channels and weak signals, the STB has
d with the option "Manual Scanning" where
data can be entered by the user.
g the "Manual Scanning" from the Installation Menu,
screen will be displayed:
target satellite for manual search. In order to scan
from the satellite which is not listed on this menu,
ellite 1', 'Satellite 2' or 'Satellite 3'.
'Satellite 1', 'Satellite 2' or 'Satellite 3',
tion about the satellite which you are interested in should be put.
nsponder.
n will enable the user to load any transponder from the preprogrammed list
within the receiver.
cially on New transponder at Load TR, this new transponder can be added
ansponder list so that you can use it on Auto Scanning later, only if at least
hannel is found with this new transponder. In order to save it, press OK key.
er to get 'NEW' as new transponder at Load TR, enter '0' at Load TR or go to
' using the / keys.
equency of the transponder you want to find.
ymbol rate of the transponder you want to find.
FEC(Forward Error Correction)of the transponder you want to find.
elect the value of 1/2, 2/3, 3/4, 5/6, 7/8 or Auto.
polarization of the transponder you want to find.
al/Vertical/Circular Left/Circular Right)
e of horizontal, 18V and in the case of vertical, 13V are output through LNB line.
n Mode "All" or "Only Free".
on Network Search. You can get more channels from transponder using
g transponder. Additionally, you can get 'Net Name' on the screen. This service
n the information from broadcasting signal.
searching "Yes". only if you are interested in SCPC program. You can manually
entering individual PID(Packet Identifier)(Video/Audio/PCR) values.
t option, press OK key to start the scan process.
GB-20
All manuals and user guides at all-guides.com
D I G I T A L S A T E L

1.6 SMATV Scanning

In case that several generations use Antenna and LNB
in common, search the service the from 950 to 2150MHz.
Select Searching Type "Automatic" or "Manual".
Select Scan Mode "All" or "Only Free".
You can input alternative symbol rate from 1st to 4th.
N N o o t t e e : 1. When your searching type is set to Automatic
during SMATV scanning, you have only to enter
the alternative symbol rate(1~4) you want.
2. When your searching type is set to Manual
during SMATV scanning, you must enter both
frequency and symbol rate.
3. DiSEqC switch can be supported for SMATV on
'LNB Settings'. SMATV as the satellite on
'LNB Settings' should be selected for supporting
DiSEqC switch.
When you select "Automatic", STB will search all available
channels based on symbol rates over whole frequencies.
On the other hand, it will scan channels with exact
information for symbol rate and frequency on "Manual".

1.7 Reset to Factory Defaults

This is to recover the Factory set values in case the user has
encountered some problems after changing any values of
channel data and others which may be in error.
The screen display will be as follows:
At the request window,
if you press OK key, the receiver will be reset to factory default
settings automatically.
N N o o t t e e : This cause your previous settings to be deleted!
All settings and information including channel data will be deleted.
L I T E R E C E I V E R
OPERATING THE RECEIVER
GB-21