In-Wall Recessed Installation - 2X4 Framing - Dimplex CEL50 Manual Del Propietário

Fireplace Installation
Figure 10
12. Carefully replace and install
partially reflective glass and
glass brackets using screws
from step 1.
13. Refer to Front Glass
Installation section, page
17 for final installation
procedures.
In-wall Recessed
Installation - 2x4 Framing
CAUTION: Two people may
be required for various steps
of this procedure.
1. Prepare a wall with a framed
opening of 46 ½" (118.1 cm)
wide x 16 ½" (42 cm) high
(Figure 10).
14
2 x 4 Framing
!
NOTE: The sizing has
allowed for 1/4" (6.4 mm) around
the fireplace insert for ease of
installation. This fireplace does not
require any additional venting.
2. Choose your method of
supplying power to the unit:
• Plug in (you may run the power
cord out of the framed wall
opening to an existing outlet or
install an outlet on a nearby wall
stud within the wall).
• Hard wire the fireplace
(recommended). Follow the
hard wiring instructions on
page 9.
WARNING: Do not attempt
to wire your own new outlets or
circuits. To reduce the risk of fire,
Figure 11
Mounting
holes
www.dimplex.com