Use And Maintenance; Up And Down Buttons; Stop Function; Favourite Position (My) - SOMFY Sunea 50 CSI io Manual

2.4.3. Restoring the original con guration
Only switch off the power to the application to be
reset.
This reset deletes all control points, all the sensors and
all the end limit settings, and resets the motor's favourite
position (my).
Position the motorised product at the mid-height position.
1)
Cut the power supply for 2 seconds.
2)
Switch the power supply back on for 5 to 15 seconds.
3)
Cut the power supply for 2 seconds.
4)
Switch the power supply back on: the motorised product
5)
moves for a few seconds. (If the application is at the
upper or lower end limit, it will make a brief up and down
movement).
Press the PROG button on the local Somfy control point
6)
for 7 s, until the motorised product moves up and
down twice:
Repeat the commissioning procedure
-
(see Commissioning) section.

3. USE AND MAINTENANCE

This drive is maintenance-free

3.1. UP AND DOWN BUTTONS

Up or Down button causes the motorised
product to raise or lower fully.
For cassette awnings, obstacle detection is active
throughout lowering.

3.2. STOP FUNCTION

The motorised product is moving.
Brie y press my: the motorised product stops automatically.
-

3.3. FAVOURITE POSITION (my)

To use the favourite position (my):
Brie y press my: the motorised product starts to move,
-
and stops in the favourite position (my).
To modify or delete the favourite position (my), see the section entitled "Additional settings".
Copyright © 2014- 2020 Somfy Activités SA, Société Anonyme. All rights reserved.
-
1 2
5 s
3 4
ON
15 s
5
ON
6
PROG.
1
2
3
my
Images not contractually binding
EN
OFF
2 s
OFF
2 s
my
21