Tool Specifications; Operating Controls; Use As Intended; Before Putting Into Operation - Würth Master SBS 28-A Manual De Instrucciones

SBS 28 A.book Seite 11 Montag, 3. Dezember 2007 9:49 09

Tool Specifications

Cordless Sabre Saw
Article number
Rated voltage
Stroke rate at no load
1. gear
2. gear
Stroke
Weight with battery, approx. 4.1 kg
Akku
Article number
Temperature control
Rated voltage
Capacity
Weight, approx.

Operating Controls

1 Saw blade
2 Guide shoe
3 Quick-change saw blade holder
4 On/Off switch with speed control function
5 Gear selector/lock-off
6 Battery
7 Clamping lever for guide bracket
8 Battery unlocking button
9 Charge-control indicator
10 Button
Not all of the accessories illustrated or described are included
as standard delivery.

Use as Intended

This sabre saw cuts wood, plastic, and metal. It cuts
curves and can cut flush to a surface.
For damage caused by usage other then intended,
the user is responsible.

Before Putting into Operation

The batteries are partially charged and delivered in
idle state. The battery must be activated before using
for the first time. For this, place the battery onto the
charger for a short time. The LED 9 on the battery
indicates the charge condition.
When the battery is not used for longer periods, it
switches to the idle state. In order to use the battery
again, it must be reactivated.
When the battery is completely discharged, it
switches off automatically (deep discharging not
possible). When the power tool is switched on none-
theless, the battery delivers only brief current pulses.
All manuals and user guides at all-guides.com
The power tool "flickers" as an indication that the
battery must be charged.
As a general rule: Should the power tool not be
SBS 28-A
operative after inserting the battery, place the bat-
0700 207 X
tery onto the charger. The indicators on the battery
28 V
and the charger then provide information about the
battery condition (see main figure).
–1
0 – 2000 min
At low temperatures, further operation is possible
–1
0 – 3000 min
with reduced power output. The battery switches off
28.6 mm
automatically below -10 °C.
Li-Ion
Battery Charging
0700 956 730
A battery that is new or has not been used for a longer
NTC
period does not develop its full capacity until after
28 V
approximately 2 – 3 charging/discharging cycles.
3.0 Ah
To remove the battery 6, press the unlocking but-
1.0 kg
tons 8 and pull out the battery toward the rear. Do
not exert any force.
Please refer to the enclosed "Battery Charger"
instructions for the operation of the battery charger
as well as for a description of the charging process.
The battery is equipped with an NTC temperature
control which allows charging only within a temper-
ature range of between -10 °C and +66 °C. A long
battery service life is achieved in this manner.
A significantly reduced working period after charg-
ing indicates that the batteries are used and must be
replaced.
Charge-control Indicator
(see main figure)
The battery 6 is fitted with a charge-control indica-
tor 9.
By pressing the button 10, the battery charge can
also be checked when the battery has been
removed, or when the machine is at a standstill
(machine must be switched off for at least 1 minute).
After approx. 4 seconds the battery charge display
automatically turns off.
When the first display element begins to flash (0 –
10 %) the battery is almost empty and must be
recharged.
Observe the notes on environmental protection.
11