Safety Instructions - Silvercrest SSMS 600 B3 Instrucciones De Uso

Safety instructions

RISK OF ELECTRIC SHOCK
► Connect this hand blender only to correctly installed mains power sockets
supplying a power voltage of 220 - 240 V ~ / 50 Hz.
► Disconnect the hand blender from the mains power socket if you notice any
faulty operation and before beginning to clean it.
► Do not expose the appliance to humidity and do not use it outdoors.
► Should liquids enter the housing, disconnect the appliance from the mains
power socket immediately and arrange for it to be repaired by a qualifi ed
technician.
► To unplug the appliance, always pull the plug from the socket, do not pull
on the power cable itself.
► Do not crease or crimp the power cable and place it in such a way as to
prevent anyone from stepping on or tripping over it.
► To avoid unnecessary risks, arrange for defective power plugs and/or
cables to be replaced at once by qualifi ed technicians or our Customer
Service Department.
► You may not open the motor unit housing of the hand blender. Should you
do so, the safety concept of the appliance may be compromised and the
warranty becomes void.
► This appliance is not intended for use by individuals (including children)
with restricted physical, physiological or intellectual abilities or defi ciences
in experience and/or knowledge unless they are supervised by a person
responsible for their safety or receive from this person instruction in how the
appliance is to be used.
► Children should be supervised to ensure that they do not play with the
appliance.
RISK OF ELECTRIC SHOCK
WARNING! RISK OF INJURY!
► Switch off the appliance and disconnect from supply before changing
accessories or approaching parts which move in use.
► Fundamentally, always disconnect the appliance from the mains power
socket when the unit is to be left unattended.
► Children may only use the blender when under adult supervision.
SSMS 600 B3
Under no circumstances may the motor unit of the hand mixer be im-
mersed in liquids, or liquids be permitted to permeate into the motor
unit housing.
GB
41