Black Max BM907500BT Guía De Referencia Rápida

WARNING:
This Quick Reference Guide is not a substitute for reading the operator's manual. To reduce the risk of injury or death, user must read and understand operator's manual before using this product. All page references refer to
the operator's manual.
IMPORTANT!
WARNING:
Using a generator indoors CAN KILL YOU IN MINUTES.
Do not connect to a building's electrical
Generator exhaust contains carbon monoxide. This is a
system unless the generator and transfer
poison you cannot see or smell.
switch have been properly installed and
the electrical output has been verified by
a qualified electrician. The connection
must isolate the generator power from
NEVER use inside a home
utility power and must comply with all
or garage, EVEN IF doors
applicable laws and electrical codes. and windows are open.
TOOLS NEEDED
PHILLIPS
Socket Wrench
SCREWDRIVER
FIRST TIME ASSEMBLY
2
1
1 4
Install the feet (see page 11).
Raise and secure the handle (see page 13).
2 Install the wheels (see page 11).
2
1
Add entire bottle of lubricant provided to the gen-
5
erator (see page 13).
3 Connect the battery (see page 12).
2
1
Set unit on flat surface so engine is level.
Remove dipstick, wipe clean, put back in hole
(but don't screw in) and check lubricant level.
BM907500BT QUICK REFERENCE GUIDE
STARTING THE UNIT
1
Add fuel (see page 13).
NOTICE:
Do not use E15 or E85 fuel in this product. It is
a violation of federal law and will damage the
unit and void your warranty. Only use unleaded
Only use OUTSIDE and gasoline containing up to 10% ethanol.
far away from windows,
doors, and vents.
Combination Wrench
This is a 4-cycle engine. Do not mix fuel and
lubricant together.
Mix fuel stabilizer with gasoline according to
manufacturer's directions prior to filling the
tank.
2
Turn the fuel valve to ON (I) (see page 15).
FUEL
VALVE ON
Place the on/off switch in the ON (I) position
3
(see page 15).
ENGINE
SWITCH ON
4 Pull choke out to START position (see page 15).
CHOKE IN
START
POSITION
MAXCONTROL
Download the Black Max
1
MAXCONTROL app
™
on your iOS or Android
Bluetooth enabled
®
device. Open the app
and follow the directions
as shown. See page 15
for more details.
Press the start button to start the engine.Engine can
5
also be started by pulling the recoil starting grip until
the engine runs. (See page 15)
PRESS THE START BUTTON
LCD display must be on to use start button. If
display is in sleep mode, press and release
pairing button or toggle on/off switch to wake.
OR PULL RECOIL STARTER TO START
Allow engine to run for 15-30 seconds, then push
6
choke in to RUN position (see page 15).
15-30 S
CHOKE
IN RUN
POSITION
STOPPING THE UNIT
Put the on/off switch in the OFF (O) position (see
1
page 15.)
2
1
ENGINE
SWITCH OFF
APP WITH BLUETOOTH
®
™
USING THE GENERATOR
1
Connect devices to be powered by generator by following the steps below (see pages 8-9).
• Make sure the generator can supply enough continuous (running) and surge (starting) watts for the items you
will power at the same time. See page 9 for how to calculate total amount of power needed.
• Start the generator with nothing connected.
• Plug in and turn on the first load, preferably the largest load you have.
• Permit the generator output to stabilize (engine runs smoothly and attached device operates properly).
• Plug in and turn on the next load.
• Again, permit the generator to stabilize.
• Repeat previous two steps for each additional load.
IMPORTANT: Never add more loads than the generator capacity. Take special care to consider surge loads in
generator capacity. (See pages 8-9.)
STORING THE UNIT
When preparing to store the generator, allow the unit to cool for 30 minutes, then follow the guidelines listed on
1
page 19.
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE
Engine will not start. On/off switch is OFF.
No fuel.
Stale gasoline or water in gasoline.
Lubricant level is low.
Fuel valve is OFF.
Spark plug faulty, fouled, or improperly gapped.
Choke is in RUN position.
Engine stored without treating or draining gaso-
line, or refueled with bad gasoline.
Dirty fuel filter.
Engine hard to start. Water in gasoline.
Weak spark at spark plug.
Electric start feature not work- On/off switch is in OFF (O) position.
ing.
MAXCONTROL LCD display is in sleep mode.
™
2
1
Battery wires are disconnected.
Battery is not charged.
Engine battery charge circuit fuse is blown.
Engine lacks power. Dirty air filter.
Engine stored without treating or draining gaso-
line, or refueled with bad gasoline.
AC receptacle does not work. Circuit breaker is tripped.
GFCI is tripped.
Item plugged in is defective.
Generator makes a "spark An occasional light "knocking" or "pinging" under
knock" or "pinging" noise. heavy load is not a cause for concern. However, if
the knocking or pinging occurs under normal load
at a steady engine speed, the problem may be with
the brand of gasoline being used.
MAXCONTROL LCD display is Battery cables are not connected.
™
not working.
Display is in sleep model.
Battery charge is very low.
If problem persists after trying the above solutions, contact customer service or a qualified service center
NOTICE:
As the equipment owner, you are responsible for the performance of the required maintenance listed in the Maintenance section. It is rec-
ommended that you retain all receipts covering maintenance on your equipment. Neglecting or failing to perform the required maintenance
may increase emissions, decrease fuel efficiency, degrade performance, cause irreversible engine damage and/or void your warranty.
Make the most of your purchase! Go to www.blackmaxtools.com
and register your new tool online. For questions about operating or
maintaining your product, please call 1-800-726-5760.
R
SOLUTION
Turn on/off switch to ON.
Fill fuel tank.
Drain entire system and refill with fresh fuel.
Engine is equipped with Low Oil Shutoff. If engine
lubricant level is low, it must be filled before unit
will start. Check engine lubricant level and fill, if
necessary.
Turn fuel valve ON.
Replace spark plug.
Pull the choke lever out to the START position.
Drain fuel and carburetor. Refuel with fresh
gasoline.
Replace fuel filter or contact a qualified service
center
Drain entire system and refill with fresh fuel.
Replace spark plug or contact a qualified service
center.
Turn the on/off switch ON ( l ).
Press and release the pairing button or toggle the on/
off switch off and on to wake the display.
Connect the battery wires.
Charge the battery.
Replace the engine battery charge circuit fuse.
Check air filter element. Clean or replace as
needed.
Drain fuel and carburetor. Refuel with fresh
gasoline. If problem continues, contact a qualified
service center.
Reset the AC circuit breaker.
Reset the GFCI.
Try a different item.
Switch to a different brand of gasoline, making
sure that the octane rating is 86 or higher. If prob-
lem continues, contact a qualified service center.
Connect the battery.
Press and release the pairing button or toggle the on/
off switch off and on to wake the display.
Recharge the battery.
for assistance.
995000540
3-6-18 (REV:01)