Loading New Software; Frequency Converter Control Panel; Firmware And Software Labelling; Upgrading The System - Nederman FlexPAK 800 Manual Del Usuario

All manuals and user guides at all-guides.com
NOTE!
Always check main filter for damage when replacing the control filter.
1.
Access the filter by removing the lid and side of the FlexPAK 800/1000 DX.
2.
Disconnect the top piping of the filter housing and open top cover.
3.
Remove and put the old filter in a large plastic bag, or wrap in plastic foil. Avoid dust
spreading.
4.
Fit a new filter cartridge in place. Ensure that the filter cartridge is centred and that the rubber
seal on the housing is intact.
5.
Close the top cover and reconnect the pipes.
6.
Check the earth connection between the control filter and GND1.
9.6

Loading new software

NOTE!
This section is only for Nederman qualified service technicians.
NOTE!
Make notes of actual parameter settings.
9.6.1

Frequency converter control panel

To change software or install new software for the unit, the parameters in the frequency converter
have to be changed by means of the frequency converter control panel available from Nederman.
9.6.2

Firmware and software labelling

The firmware and software revision can be read in the PLC and also on the label on the PLC.
The number, 2155264.2.26 for example, consists of the following parts:
•
2155624 = The software number.
•
2.2 = The revision.
•
6 = An E-Prom that has been programmed with a LOGO 6 unit.
NOTE!
Never upgrade a LOGO with an EPROM that has a different last number. For example, if
the EPROM was programmed with a LOGO6, you cannot use it to upgrade a LOGO5.
NOTE!
To find the firmware and software revision number in the PLC display, see Figure
8, item 1. Pressing 'OK' when the PLC displays this menu will show this information. See also
Section '7.1 Find a parameter and set its value'.
9.6.3

Upgrading the system

Upgrade the system as follows:
1.
Turn off the power supply.
2.
Remove the cartridge cover, see Figure 8, item 2.
3.
Insert the EPROM.
4.
Turn on the power supply and wait until the program has been loaded. This will take a few
seconds.
5.
Turn off power and remove the EPROM.
6.
Refit the cartridge cover.
7.
Turn on power and make the required parameter settings according to the manual for the
starter, or set them according to notes from previous settings.
8.
Store the EPROM in a safe place.
9.7

Spare parts

Contact your nearest authorized distributor or Nederman for advice on technical service or if you
require help with spare parts. See also www.nederman.com.
FlexPAK 800/1000 DX EN
51