Connect Drain Hose - KENMORE ELITE Oasis HE 110.2806 Serie Manual De Uso Y Cuidado

3. Using 2 or more people, tip the washer onto its back and
place on cardboard supports.
4. Remove foam shipping base.
5. Set washer upright.
6. Remove tape from lid. Open lid and remove foam packing
ring from washer tub. Keep foam packing ring in case you
need to move the washer in the future.

Connect Drain Hose

Proper connection of the drain hose protects your floors from
damage due to water leakage. Read and follow these
instructions.
The drain hose is connected to your washer and is stored inside
the washer cabinet.
All manuals and user guides at all-guides.com
Remove drain hose from washer cabinet
Pull the corrugated drain hose out of the washer by first grabbing
the pull tie. Continue to pull the hose until the end emerges. Do
not force excess drain hose back into the rear of the washer.
Laundry tub drain or standpipe drain
Connecting the drain hose form to the corrugated
drain hose
1. Feed end of drain hose into one end of form. Place end of drain
2. Bend the hose over the top of the form and feed into the other end
To keep drain water from going back into the washer:
■
■
Floor drain
Do not install the drain hose form on to the corrugated drain
hose. You may need additional parts. See Floor drain under
"Tools and Parts."
A
A. Drain hose reliefs
hose form into the drain hose relief.
of the form. Attach the other end of the form into the other drain
hose relief. The hose must extend 4½" (11.4 cm) beyond the form.
Do not force excess drain hose into standpipe. Hose should
be secure but loose enough to provide a gap for air.
Do not lay excess hose on the bottom of the laundry tub.
4.5"
(11.4 cm)
7