S-Video Connection - JVC HR-S8006UM Manual De Instrucciones

Connect the power plug to an
AC outlet before installing the
lithium battery. (See below)
Back of VCR
AC Power
Cord
To S VIDEO OUT
To AC Outlet
To S Video Input
Connector
NOTES:
To make the most of the Super VHS picture performance we
recommended that you use the supplied S-VIDEO cable to
connect your VCR to a TV with an S-VIDEO input connector.
To operate the VCR with your TV using the S-VIDEO
connection, set your TV to the AV mode using the TV's
remote control.
You can also use the TV/VCR button on the VCR's remote
control to set your TV to the AV mode. (
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Be sure to connect the power plug to an AC outlet first
before installing the lithium battery; otherwise, the
battery's service life will be drastically shortened.
Antenna or Cable
IN OUT
R
AUDIO
S VIDEO
IN OUT
L
(MONO)
VIDEO
S-Video Cable
(supplied)
To Audio/Video Input
To Antenna Input
pg. 41)
A
Flat Feeder
Coaxial Cable
CH3
REMOTE PAUSE/ CH4
AV COMPU LINK
To AUDIO/
VIDEO OUT
Audio/Video
Cable
(supplied)

S-VIDEO Connection

Connect VCR to TV
a– Connect both the RF cable and the AV cables to the TV as
explained in step 3 of "Basic Connections" (
b– Connect the the S-Video cable between the S-VIDEO OUT
jack on the rear of the VCR and the S-Video Input on the
TV.
Installing/Removing the lithium battery
1
Make sure that the power plug is connected to an AC outlet
and turn off the VCR power.
2
Open the battery cover while pressing the release tab as
illustrated.
3
Insert a lithium battery with the plus (+) side up and push it
in.
To remove the lithium battery, press the latch A down-
ward using a pointed non-metallic object, then pull out
the lithium battery.
4
Close the battery cover until it clicks in place.
To ANT. IN
Matching
Transformer
(not supplied)
ANT. IN
RF OUT
To RF OUT
RF Cable
(supplied)
pg. 4)
5
EN