Tabla de contenido
Idiomas disponibles
Idiomas disponibles
4
EN
Connections
Antenna or Cable
Coaxial Cable
Flat Feeder
AC Outlet
AC Power Cord
S VIDEO
IN
OUT
Back of VCR
Audio/Video
Cable
(supplied)
TV
NOTES:
The VCR channel is the channel on the TV which will display
the audio and video signals from the VCR. The VCR's CH3-
CH4 switch, on the back of the VCR, sets the VCR channel to
CH3 or CH4.
The CH3–CH4 switch is preset to the CH3 position.
Set to CH4 if CH3 is used for broadcasting in your area and
set the channel on the TV to correspond to the VCR's CH3–
CH4 switch setting.
If RF connection to TV is used, when switching from VCR to TV
mode and from TV to VCR it may be necessary to issue a CH UP
and then CH DOWN on TV to obtain a good quality picture.
Even if you are using AV cables to connect your VCR to your
TV, you must also connect it using the RF cable. This will
ensure that you can record one show while watching another
(
pg. 24).
For full identification of the VCR's rear panel, refer to the
Index (REAR VIEW
ANT. IN
(Antenna or Cable input)
Matching
Transformer
(not supplied)
IN
OUT
ANT. IN
R
AUDIO
L
(MONO)
RF OUT
CH3
VIDEO
REMOTE PAUSE/
CH4
AV COMPU LINK
75 ohm terminal
300 ohm terminal
Back of VCR
CH3
SE/
K
pg. 49).
INSTALLING YOUR NEW VCR
Basic Connections
CHECK CONTENTS
1
Make sure the package contains all of the accessories
listed in "SPECIFICATIONS" (
SITUATE VCR
2
Place the VCR on a stable, horizontal surface.
CONNECT VCR TO TV
3
The connection method you use depends on the type of
TV you have.
RF Connection
RF OUT
AV Connection
RF Cable
(supplied)
S-VIDEO Connection
CONNECT VCR TO
POWER SOURCE
4
Connect the power plug to an AC outlet.
CH4
FINAL PREPARATION FOR
USE
5
Select the VCR channel (3 or 4) by setting the switch on
the rear of the VCR as shown in the illustration.
Perform "Plug & Play" (
To Connect To A TV With NO AV Input Terminals . . .
a– Disconnect the TV antenna from the TV.
b– Connect the TV antenna cable to the ANT. IN jack
on the rear of the VCR.
c– Connect the supplied RF cable between the RF
OUT jack on the rear of the VCR and the TV's
antenna terminal. Set TV on CH3 or CH4
corresponding to the CH3 – CH4 switch setting on
the back of the VCR.
To Connect To A TV With AV Input Terminals . . .
a– Connect the antenna, VCR and TV as shown in
the illustration.
b– Connect an Audio/Video Cable between the AUDIO
OUT and VIDEO OUT jacks on the rear of the VCR
and the AV IN jacks on the TV. Set your TV in video
input mode or A/V input mode. Refer to the TV
Instruction Manual.
If you have a TV with S-VIDEO input terminals, see
"S-VIDEO Connection" on page 5.
pg. 6 and 7).
pg. 51).
Capítulos
Tabla de contenido
