Federal Signal Corporation ELECTRAFLASH 141-012 Hoja De Instrucciones página 2

INSTRUCTION SHEET FOR FEDERAL MODELS 141-012,
I. INSTALLATION.
Failure to follow all safety precautions and instructions may result in property
Follow all instructions shipped with this product. This device is to be installed by a trained
electrician who is thoroughly familiar with the National Electrical Code and will follow the NEC
and SAE Guidelines as well as local codes.
The selection of the mounting location for the device, its controls and the routing of the wiring is to
be accomplished under the direction of the facilities engineer and the safety engineer. In addition,
listed below are some other important safety instructions and precautions you should follow:
• Read and understand all instructions before installing or operating this equipment.
• Do not connect this light to the system when power is on.
• After installation, test the light system to ensure that it is operating properly.
• After testing is complete, provide a copy of this instruction sheet to all operating personnel.
• Establish a procedure to routinely check the light system for proper activation and operation.
A. Unpacking.
After unpacking the Model 141, examine it for damage that may have occurred in transit.
If the equipment has been damaged, do not attempt to install or operate it. File a claim
immediately with the carrier stating the extent of the damage. Carefully check all envelopes,
shipping labels and tags before removing or destroying them.
B. Mounting.
This light is intended for indoor or outdoor use. If using the light outdoors, it MUST be mounted
in a vertical position. To mount the light, proceed as follows:
1. Using the template in figure 1, locate three
mounting location.
When drilling holes on ANY part of a vehicle, ensure that both sides of the mounting
surface are clear of parts that could be damaged, such as brake lines, fuel lines,
2. Drill three 1 /
3. Install a user-supplied grommet in the
4. Splice two lengths of wire (user-supplied) to the power leads coming from the bottom of
the light. Insulate the splices.
5. Route the power leads through the previously installed grommet.
6. Remove the two screws located at the bottom edge of the dome. Retain these screws.
7. Remove dome from light.
8. Attach the light to the mounting surface with user-supplied screws (as shown in figure 2).
Ensure that all screws are tight.
9. Place the dome over the base. Align screw holes in dome and base. Insert previously
removed screws and tighten.
141-024, AND 141-036 ELECTRAFLASH
damage,serious injury, or death to you or others.
SAFETY MESSAGE TO INSTALLERS
electrical wiring or other vital parts.
" holes and one 3 / " hole at the appropriate locations in the mounting surface.
4 8
WARNING
1 / " holes and one
4
CAUTION
3 / " hole.
8
1
® LIGHT
3 / " hole at the
8