Tabla De Contenido; Electrical Requirements; Factory-Assembled Features; Product Notices - Kohler Sonata K-1683 Manual Del Usuario

Important Information
When using electrical products, basic
WARNING:
precautions should always be followed, including
the following:
DANGER: Risk of electric shock. Connect only to a
circuit protected by a Ground-Fault Circuit-Interrupter
(GFCI).
Building materials and wiring should be routed away from the pump
body and other heat-producing components of the unit.
Install to permit access for servicing.
Grounding is required. The unit should be installed by a qualified
service representative, and grounded.

Electrical Requirements

The installation must have a Class A Ground-Fault
Circuit-Interrupter (GFCI). The GFCI protects against line-to-ground
shock hazard. Use a 120 V, 15 A, 60 Hz dedicated service for the
whirlpool.
"H" models require a separate 120 V, 15 A, 60 Hz dedicated service
for the in-line heater.

Product Notices

WARNING: Unauthorized modification may cause
unsafe operation and poor performance of the whirlpool.
Do not relocate the whirlpool pump, or make other
modifications to the whirlpool system, as this could
adversely affect the performance and safe operation of the
whirlpool. Kohler Co. shall not be liable under its warranty
or otherwise for personal injury or damage caused by any
such unauthorized modification.
Table of Contents
Thank You . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Before You Begin . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Recommended Tools and Materials
Prepare the Site . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Construct the Framing . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Install the Module . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Cut the Pump Banding Straps
Install the Plumbing . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Make Electrical Connections
Test Run the Whirlpool . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Complete the Finished Wall
Clean-Up After Installation
Confirm Proper Operation
Troubleshooting Procedures
B
1022475-2-
. . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . .
WARNING: Risk of electrical shock. A licensed
electrician should make all electrical connections.
WARNING: Risk of electrical shock. Disconnect
power before servicing.
WARNING: Risk of injury or property damage.
Please read all instructions thoroughly before
beginning installation, including the following
requirements.
NOTICE: Follow all local plumbing and electrical codes.

Factory-Assembled Features

Factory installed components include pump with power
supply cord and air switch transmitter. No installation is
needed.
"H" models are also supplied with a factory assembled,
in-line heater.
An optional timer kit is available for this product.
The whirlpool pump and piping are factory-assembled.

Connections and Service Access

Before installation, ensure proper access to the final
connections.
NOTICE: Provide unrestricted service access to the pump.
You must provide access for servicing the pump and
controls. The access must be located immediately next to
the pump. Study the roughing-in information packed with
the whirlpool.
3
3
3
4
4
5
6
7
7
8
8
8
9
10
2
Kohler Co.