Specified Conditions Of Use; Water Connection - Milwaukee DR 152 T Manual Original

SPECIFIED CONDITIONS OF USE

The diamond drill stand is intended for use with Milwaukee diamond
drills. It must be attached to the oor or wall by means of anchors.
Do not use this product in any other way as stated for normal use.
OPERATION WITH A VACUUM PUMP
The substrate under the drill stand has to be clean, rm, smooth,
dry, and not have any holes in it. The use on plaster or masonry is
not possible.
In case of malfunction, stop the work immediately and remove the
drill stand completely.
In case of a malfunction, the vacuum only remains for a short peri-
od of time. The retention force depends on the substrate and seal.
Additionally secure the drill stand against falling, e.g. with rope or
suitable supports.

WATER CONNECTION

Core drilling requires the application of water. Supply an adequate
water ow!
An adequate supply of water must ow freely and constantly during
the entire cut. This Coring Motor is equipped with a built-in water
passage to allow water to ow down the inside and up around the
outside of the bit. This acts to cool the bit and ush cuttings from
the hole.
MAINTENANCE
Use only Milwaukee accessories and Milwaukee spare parts. Should
components need to be replaced which have not been described,
please contact one of our Milwaukee service agents (see our list of
guarantee/service addresses).
If needed, an exploded view of the tool can be ordered. Please
state the Article No. as well as the machine type printed on
the label and order the drawing at your local service agents or
directly at: Techtronic Industries GmbH, Max-Eyth-Straße 10,
71364 Winnenden, Germany.
SYMBOLS
CAUTION! WARNING! DANGER!
Always disconnect the plug from the socket before
carrying out any work on the machine.
Please read the instructions carefully before starting the
machine.
Wear ear protectors!
Always wear goggles when using the machine.
Protect your head from injury from falling brickwork.
Always wear a protective helmet.
Wear gloves!
Accessory - Not included in standard equipment, available
as an accessory.
Do not dispose of electric tools together with household
waste material. Electric tools and electronic equipment
that have reached the end of their life must be collected
separately and returned to an environmentally compatible
recycling facility. Check with your local authority or
retailer for recycling advice and collection point.
European Conformity Mark
British Conformity Mark
Ukraine Conformity Mark
EurAsian Conformity Mark
GB
English
19